I have a 98 intruder 1500 lc and every time i have power to the battery the starter starts spinning even with out key in. any ideas

SOURCE: CHANGING PLUGS IN 2001 1500

dear sir have your battery tested with a volt meter should read 12.7 volts if batt is good. it sounds like your batt is low on voltage.

Terrie Thiessen

• 302 Answers
• Posted on Sep 23, 2009

SOURCE: how to remove rear wheel on suzuki intruder 1500 LC

Here's a manual:
www.onlinefreeebooks.net/automotive-machinery.../suzuki/

Hope this helps.

SOURCE: I have a 1999 suzuki intruder 1500 lc will not

An engine needs spark, fuel and air to run. The first thig to check is that you are getting spark to all cylinders. If you do not have spark then it is an ignition problem. If you do have spark then it is either a fuel, air or timing problem.

If you do not know how to check for spark you should be able to find instructions very easily, its a simple proceedure.

SOURCE: suzuki intruder 1500 LC I have problem with

Intruder carbs are notorious for this issue. What you have going on is that the needle seat has become worn out. The problem is, that this carb was designed with pressed in needle seats that cannot be removed. You will need to search online for an intruder carb rebuilder that can press in the seats for you, as well as change the seals, replace the needle, check the diapragm and jets, and replace/clean the floats. OR, you can try to find new carbs online from a wrecked or used Intruder 1500 VL.

SOURCE: I have a 1999 Suzuki Intruder 1500 LC motorcycle.

check your decompresson cables if they dont open the starter will drag rear cyclender is the problem on mine easy fix