Motorcycles Logo

Related Topics:

Anonymous Posted on Feb 06, 2012

My kawasaki zzr1100 d1 starts and runs but when i ride it it doesnt pick up propley

Changed oil and filter and cleaned air filter and spark plugs and one coil checked .drained fuel cleaned carbs.the bike ran fine to the m.o.t. left it there for one hour then as soon as left m.o.t. place it started to play up dieing then then back then all over again

  • Marvin
    Marvin Feb 06, 2012

    Is it misfring?

×

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Jul 13, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Jul 13, 2013
Answers
1
Questions
0
Helped
687
Points
0

Mine was down to blocked jets from standing, used ultrasonic gadget to clean main and pilot jets, running nicely now

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 77 Answers
  • Posted on Feb 06, 2012
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Feb 03, 2012
Answers
77
Questions
0
Helped
35559
Points
205

Fuel issue (could be clogged jets)
Loose spark plug boots (lack of spark could cause it as well).

Clogged exhaust making excess exhaust pressure.

Testimonial: "thanks it was getting fresh oil on one and 4 that gone as changed oil and filter and changed all plugs and the coil on one and four and cleaned air filter.i will try to clean carbs more and try my other endcan tommorow"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a John Deer riding lawn mower SX95 with a fb460v kawasaki engine that only starts with fuel dropped into carburetor I have a good spark , I had changed the oil and filter , I also took the carb...

in the carb did any of the screws have any micro bored holes for gas to go through like in many small engine iv found . clogged with goop. does it have a gas bowl an a screw on bottom take it out if does an look it over close.
0helpful
1answer
0helpful
1answer

Kawasaki FH641V riding lawn mower engine not starting I removed, cleaned and reinstalled carb. Installed new spark plugs, and one bad coil, cleaned the air filter, changed fuel lines and in line filter,...

You can have current reach the coil but if it is open or if there is an internal short it may also produce a weak or no spark at all. High voltage has to come out of there and it has to be distributed to the various plugs. You have more than one plug so check the distributor out also.
0helpful
1answer
1helpful
1answer

Hi i would just like to know if there is a common problem with the kx 65 I took my son riding today and the bike was running good then it stalled on him now it won't run I got it started for 5 sec then...

No common problems to the KX in particular but very common to all race bred 2 strokes is they all require lots of love and attention so clean air and pilot jets regularly clean air filters regularly make adjustments to the fuel air mix screws to suit time of day and altitudes etc regularly and if you ever have problems starting and stalling throw away the spark plug and replace as you no doubt would have fouled it and the plugs never return back well after that no matter how new they may be!
Revisit your fuel oil mix also depending how you ride and where you ride you may want anything from 30:1 mix to 50:1 mix to give reliability (35:1 - 40:1 mix is good place to start?)
I would change spark plug and clean pilot jet in carbi as first steps for this problem then once sarting again do some tests on different fuel mixes (small steps at a time though) to see what works best
good luck regards Jamie
1helpful
1answer

Oil Light comes on when engine is warm on my ZZR1100 D1, have alterd the revs but then revs too high

Change your oil pressure sender switch. It should fix the problem. If it does not you will need to replace the oil pump.
0helpful
2answers

Kawasaki KRB750 B: Won't start. Have spark,

Check your off/on switch you can test it with an ohm meter to see if you are getting a open curcuit
1helpful
1answer

My kawasaki 400 bayou runs but doesnt have enough power that it u

I found all spark plugs do not work well in the Bayou, especially NGK....try a champiion spark plug..it may fix the problem.
My Bayou use to stall all the time with the NGK spark plug, but runs good with the Champion spark plug.
Not finding what you are looking for?

697 views

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...