At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
My head lights on my aprillia sr 50 keep on going off every time I put high beam on and then the lights won't turn on for a a day or two after THAY gone off dunno wat it could be
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
ok, first ,, check all the bulbs again, and *** make sure that your hands never touch the actual bulb, these lights will turn the oils from your hands into cooking grease when it comes to these bulbs and cause them to blow out much to early on in their life span, , next,, Pull the light switch ( high beam switch towards you for a quick flash of the head light high beams,, if this doesn't make the high beams come on, your problem is going to be in the switch itself ( what your calling the high beam/turn signal lever) before going to that extreme though,, if you have a junk yard near you, go pull one of the relays off a junked vehicle, and stab it into your system one at a time, it could be something as simple as a relay heating up and disconnecting prematurely due to heat ,, if you don't have a junk yard that you can grab a relay,, here is a link that shows how to check them, But its time consuming http://www.youtube.com/watch?v=C8t25GjZ6i4&NR=1
The day time running light module on the back side of the front drivers fender likely needs to be replaced to fix your problem.Unplug it and the lights will work normally from the headlight switch but the day time running lights won,t work and also the high beam indicator light in the dash won,t come on when you switch to high beam but all the lights will work properly.You should replace the drl module as soon as you can but unplugging it will at least keep you from having to remove a battery cable.
Good day:
the following is what you can do to test to see whats going on turn on the headlights,put in high position
2.leave light in high, disconnect the head light dimmer switch, connect a fused jumper between head light relay supply voltage circuit of the dimmer switch and the control circuit of the head light relay. if the high beams come on then replace the dimmer switch, if the high beams don,t come on then.
3.use a fused jumper across the battery positive voltage supply circuit and the switched high beam voltage supply circuit. if the high beam come on now replace the head light relay, if the high beams don't come on then you will have to replace the LH I/P fuse block. I would most likely say that it's the relay just because of the year. I gave you a lot here I hope this helps
×