Where is flasher located on fatboy - 1993 Harley Davidson FLSTF Fat boy

The turn signal flasher on a 2014 Kia Sportage is typically located in the vehicle's fuse box. The exact location of the flasher will depend on the specific make and model of your Sportage, but it is generally located near the steering column or under the dashboard.
Here are the steps to locate the turn signal flasher:

1. Locate the fuse box: The fuse box in a Kia Sportage is typically located under the dashboard on the driver's side of the vehicle.
2. Identify the flasher: Once you have located the fuse box, look for the turn signal flasher, which is typically a small, rectangular box with two or three wires connected to it.
3. Test the flasher: Once you have found the flasher, you can test it by turning on the hazard lights and checking to see if the flasher is clicking. If it is not clicking, the flasher may be faulty and will need to be replaced.

Question edited for clarity.
Question moved to sub category.

Fuses information in the link

https://www.google.com/search?q=2007+harley+fatboy+fuel+injector+fuse+location

..

perhaps the flasher relay has failed

Wiring isn't correct. Need to check to make sure the right wires are going to the turn signals. Make sure the flasher is good too.

No, your bike is equipped with a turn signal cancelling unit instead of the old style flasher. It is usually located underneath the dash and speedometer on the Softail series of bikes. It's a "black box" about 1 1/2" wide X 3" long X 1/2 thick with a large plug on the face on one end and mounting bolt in the center. If you'll contact me directly, I'll send you a trouble shooting guide. [email protected]

Steve

Turn on the good indicator - find where the clicking comes from, this is the flasher unit - pull it off (little box 4/6 pins) and get a replacement, that should fix your problem 1st time. A good harley dealers should stock the flasher unit but you may have to wait a few days for order at smaller establishments.

likely to be a turn module.But check power input to module from switch block