If old gas sat in the carb. for more than a month it starts to dry up. As it drys up it leaves behind a varnish like film that stops up some very small ports and pin holes inside a motorcycle carburetor. It is also very hard to get out. You can try this before you pull the carb. for a full cleaning. Use a product called Seafoam, get as much gas out of the carb.s as you can. use a turkey baster and force the seafoam into your carb. fuel line that you take loose from the fuel tank. Let that set for say 1 or 2 days. then hook up the fueltank with a mix of good gas and seafoam, (not a lot but enough to start it up. Move the cycle outside as the seafoam will make a lot of smoke if it does start up. If that does not clear up the problem you may have to pull the carb. and remove the blows to clean the inside. If you have to do that do not DO NOT MESS with any adjustment screws. Just take the carb. bowl off. Do not mix up any internal parts. It is best to work on a large sheet so if you drop a small part you can find it, you do not want to be missing some tiny spring or screw. Hope this Helps Fix Ya Up..
http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html
--------------
Engine stalls or RPM
fluctuates at idle up and down or dies near idle.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
1,091 views
Usually answered in minutes!
×