Question about Xispa VN 1700 Light Tourer Motorcycles

Open Question

I'm having issues with the moped (TaoTao 50) accelerating. I will start it and it will go to 30mph then rapidly slow down after a minute or so and then have issues starting with a push button start.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Techjoel
  • 79 Answers

SOURCE: 2003 Geely 50cc Moped wont start without starting fluid.

Both types would use fuel enrichment to make the fuel/air mixture richer for cold starts. Motorcycles deliver extra fuel to the intake through small holes in the intake bore when the choke is activated. When cleaning, use something soft like a plastic broom bristle (not metal wire) to avoid scratching the inside of the jet or passage.

Good luck,
Techjoel

Posted on May 25, 2009

Ad
  • 139 Answers

SOURCE: peugeot jet force 50 engine cuts out on overrun

when the engine dies pull out the spark plug and earth the plug on the metal part and turn it over dont hold the spark plug as you will get a shock if the plug sparks you know the ignition system is working.if you have no spark do a compresion test to see if there is a problem with the engine.if that ok you will have a fuel problem make sure the breather on the fuel tank isn blocked or trapped.

Posted on Oct 08, 2009

  • 397 Answers

SOURCE: brand new taotao 50 scooter....every

Make sure it isn't a cable acutated disk brake. If it is, it is possible to adjust some slack into it. If the brake is indeed hydraulic, you wont be able to adjust it. A lack of brake fluid wouldn't cause the brake to drag. You could check for return springs and make sure the pads are seated into the caliper correctly. You could even disassemble the brake and use brake grease on the sliding parts. If the drag is very slight, I wouldn't worry about it; the drag will disappear within the first few miles especially if you use the brakes.

Posted on Jun 27, 2011

  • 3567 Answers

SOURCE: my 50 cc moped starts

Remove the carburetor then remove the float bowl on the bottom of the carb. Now clean the carb using spray carb cleaner from the auto parts store.

Posted on Sep 03, 2011

  • 1755 Answers

SOURCE: My Peugeot vivacity 50cc moped won't start just

Hi, Check fuel tank that it has fuel. Check sparkplug and/or replace it. Make sure engine has spark when cranking it over. Good luck.

Posted on Sep 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

TaoTao 50 lights stopped working


Hi, David if your headlight is not working, intermittent, only one beam works, keeps burning out, blinking, dim or surges from bright to dim to bright the first thing you need to check is the headlight bulb for damaged filaments then check your light circuit fuse, then check your headlight bulb socket ground wire for a clean tight connection, that being said the usual suspects are:
1. Faulty ground or power supply wire to headlight bulb socket.
2. Worn down solder contacts or loose fit of the bulb base in the socket due to vibration.
3. Worn, chafed, or broken wires in the light circuit.
4. Corroded, broken, or loose pins/sockets in wire connectors.
5. Faulty hi/low beam switch.
6. Faulty ignition switch.
7. Fuse is good but no continuity on both sides.
8. Faulty headlight relay.
9. Faulty wiring between battery positive and headlight bulb socket.
10. Weak charging alternator/generator/lighting coil
11. Faulty voltage regulator/rectifier ground or overcharging.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
taotao 50 headlights not working 49ccScoot com Scooter Forums
LIGHTS DON WORK MOPED SPEEDFIGHT MARK SAVAGE
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
https://www.taotaopartsdirect.com/?https://www.taotaopartsdirect.com&gclid=CjwKCAjworfdBRA7EiwAKX9HeMuuSzQUP4hOAQLY96E2cN47NtpXwiuE4vPBnPdME5U9hXt2TrIAqxoCU9sQAvD_BwE
http://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

Sep 29, 2018 | Motorcycles

1 Answer

Tao Tao 50 how to replace the crankshaft seals


Hi, Crystel for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your TaoTao, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing and printing please click on the blue links below. Good luck and have a wonderful day.
Crank Seal replacement 49ccScoot com Scooter Forums
GY6 50 Scooter Crankshaft Oil Seal Removal Install With Lisle Puller
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
Home Taotao Parts Warehouse
http://www.49ccscoot.com/manuals/ATM50-A1%20Manual.pdf

Jul 27, 2018 | Motorcycles

1 Answer

Have a Tao Tao Moped 49cc. Runs ok but when I accelerate it dies. What are options


Hi, Richard and the usual suspects are:
1. Idle port, transfer ports, slow air jet clogged.
2. Idle adjusting screw set too low.
3. Air fuel mixture adjustment too lean.
4. Pilot/slow fuel jet clogged.
5. Faulty accelerator pump.
6. Float level too low.
7. Float bowl contaminated old fuel, water, dirt, rust, etc.
8. Carburetor bowl vent line clogged/blocked/pinched.
9. Fuel line to carburetor kinked or pinched.
10. Fuel filter clogged.
11. Intake manifold leak.
12. The gas cap is not venting properly or fuel tank venting system blocked.
13. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
14. Needle and seat stuck closed in the float bowl.
15. Multi carburetors not in sync.
16. Faulty fuel pump.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
TaoTao 50cc scooter won run good Help please
Scooter dies when adding throttle It Is The Ride
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
TaoTao 49cc Scooter Parts
TaoTao ATM50 A1 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Oct 09, 2017 | Motorcycles

1 Answer

2017 TaoTao 50 replace air filter


Hi, Bob for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Amazon com Poweka New 39mm Air Filter Gy6 Moped Scooter Atv Dirt Bike...
TaoTao 50cc Scooter DIY Air Filter Replacement PT 1
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
TaoTao Scooters Mopeds Parts
TaoTao ATM50 A1 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Aug 06, 2017 | TaoTao Manufacturer Inc Motorsports

1 Answer

2014 TaoTao ATM 50 fuel and vacuum line routing


Hi, Tammy for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing and printing please click on the blue links below. Good luck and have a wonderful day.
Fuel and Vac Line Tutorial
How to simplify vacuum hoses on scooter
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
Dirt Bike Dirt Bikes ATV ATVs Moped Mopeds Dirt Bike Part ATV Part Parts...
TaoTao ATM50 A1 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e



Jul 25, 2017 | Motorcycles

1 Answer

Which service repair manual do i need ?


Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
TAOTAO under 50cc Scooter Fully Automatic VIP 50 10 Tires CY50
Two hoses that run from the carburetor Is the upper hose cut and zip tied...
Scooters TAOTAO USA INC
TaoTao 50cc Scooter Owners Manual
TaoTao Scooters Mopeds Parts

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Feb 07, 2017 | Motorcycles

1 Answer

Traction warning light comes on at 30mph and puts it in safe/limp mode - can't get faster but also doesn't slow down unless I press the break (even when not touching the accelerator)


Probly a computr issue...dont guess on parts. Unplug it and clean pins..then plug back in..see if car reboots. If no git it scand but find anothr mech. Go to surecritic.com

Jan 13, 2016 | Mini Cars & Trucks

1 Answer

How do I change the rear turn signal bulbs on a TaoTao 50CC @


Hi, Kennie for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your TaoTao, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
How to change turn signal bulb in Yamaha Vino 50cc Scooter XC50
taotao 50 ATM 01 How do you get to rear turns signals 49ccScoot com...
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
TaoTao Scooters Mopeds Parts
TaoTao ATM50 A1 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Oct 09, 2014 | Motorcycles

1 Answer

Moped won't stay running on low throttle, it will


Your IDLING JET IS CLOGGED or the settings on the SLOW speed on the idling screw is not correct. Sometimes dirt can cause issues and so it might need an overhauling of the carburater.

Jul 28, 2011 | 2007 Generic XOR 50

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Xispa Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5821 Answers

Marvin
Marvin

Level 3 Expert

84540 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Xispa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...