Razor Motorcycles - Recent Questions, Troubleshooting & Support


Hi, Chris31182 derestrict is a negative term rider's use to express their wish to improve performance on their bike or scooter. Depending on the country and motor vehicles laws some bikes and scooters are designed to conform with said laws and their performance is slightly lower than other countries. All vehicles in the world are designed to perform at 75-80% of their maximum potential, this ensures the longevity of the engine. Derestricting or improving performance is always possible on any vehicle but the tradeoff of engine longevity numbers go down, how much depends on the number and type of performance upgrades. Your local dealership or reputable independent shop are best equipped to provide you with technical data and willingness to comply with your needs.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.mychinamoto.com/forums/showthread.php?7530-derestricting-lexmto-street
https://www.youtube.com/watch?v=1prKRA5G0Pw
https://haynes.com/en-gb/motorcycle-manuals/sinnis
https://www.chinesemotorcyclepartsonline.co.uk/manufacturer/Sinnis/QM125-2V/0
http://www.mychinamoto.com/forums/showthread.php?3991-Wanted-user-manual-for-Sinnis-Max-Lexmot-Street-Zennco-Bullet-QM125-2V

Motorcycles | Answered 8 hours ago


Hi, my friend, if you receive any booklet or user manual when you bought that item from market, can be helpful for your query. You can also use following link further:
https://electricscooterparts.com/troubleshootingbatteriesarenotcharging.html

Motorcycles | Answered Yesterday


Hi, Emma-Kate before testing any electrical component in the Starting Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Engine Run Switch is "FAULTY" or corroded.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand, clutch, neutral safety switch.
10. Security alarm needs a reset.
11. Starter relay, solenoid, starter motor or circuit wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. Faulty ignition relay.
15. The electric starter is working but starter clutch has failed.
16. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
What To Do If Your Motorcycle Doesn Start
3 Things to Look for When Your Motorcycle Won Start The Allstate Blog
Scooter Service And Repair Manuals
https://www.scooterdynasty.com/stockoempartsforscooters-32.aspx
http://mail.tsimn.com/moto_q9h_user_manual.pdf

Motorcycles | Answered 3 days ago


Hi, William for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your TaoTao, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.reddit.com/r/TaoTao/comments/95ttxg/rear_wheel_removal_on_taotao_ate501
Taotao ATM150 Evo scooter rear wheel removal part 2
http://www.taotao.us/index.cfm/scooters/ate-5011
Where to find ATE 501 parts
TaoTao 50cc Scooter Owners Manual

Motorcycles | Answered 3 days ago


Hi, John_bourque for more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://driving-tests.org/vin-decoder
VIN Decoder Motorcycle Identification Cyclepedia
Sunny Trike Scooter MC D150TKA Assembly instruction part 3 the end
http://www.trikezone.com/trike-motorcycle-parts-service.php
https://www.icetrikes.co/support/owners-manual

Motorcycles | Answered 3 days ago


Hi, Gary and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://www.lexmoto.co.uk/LJ125T-8M/parts/30413_carburettors.php
https://www.youtube.com/watch?v=QVGCpyc-HpQ
https://www.ebay.co.uk/itm/Haynes-Chinese-Motorcycle-Service-Repair-Manual-4768-for-Zongshen-ZS50QT/183749575797?epid=2224859891&hash=item2ac8540475:g:ETUAAOSw9x5cmojF $25
https://www.chinesemotorcyclepartsonline.co.uk/microfiche/8047
https://www.bikingdirect.com/shop/lexmoto-owners-manual-pdf

Motorcycles | Answered 3 days ago


Hi, Mitchell for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Lexmoto, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Fuse+box+location+Lexmoto+Milano+125&tbm=isch&source=univ&sa=X&ved=2ahUKEwj04Jvsy9fhAhULrVkKHS3lB1YQsAR6BAgHEAE&biw=1440&bih=757
https://www.youtube.com/watch?v=L0qXHGMz6ls
https://www.courtesyautosalesprescott.com/lexmoto_manuals_download.pdf
https://www.lextekproducts.com/for/LEXMOTO/MILANO+125+EFI
https://www.bikingdirect.com/shop/lexmoto-owners-manual-pdf

Motorcycles | Answered on Apr 17, 2019


top of the cylinder head

Motorcycles | Answered on Apr 17, 2019


If you know it's the side stand switch, most switches are in and Open or Closed state. When the stand is down, I'm going to guess the circuit is open, and when you put the stand up the circuit is closed. It's one or the other right?
So if you're stuck, I'd first try disconnecting the switch and see if the bike starts then. If that doesn't work then you can try shorting out the switch so it closes the circuit and you can start the bike. I'm not familiar with the actual electrical socket on your bike but see if putting some aluminum foil across the prongs will close the circuit for you and you can start the bike? If that works, get a new switch. Good Luck.

Motorcycles | Answered on Apr 17, 2019

Not finding what you are looking for?
Razor Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Razor Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5821 Answers

Marvin
Marvin

Level 3 Expert

84540 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Razor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...