Tip & How-To about Motorcycles

Reset Maintenance warning light on Lexmotto Michigan 125 efi

After nobody could help me reset the maintenance light on my lexmotto michigan 125 efi. Here is how I solved it.

remove the seat and underneath u will see the relay


Just unplug the relay and keep unplugged for a minute. Plug it back in put seat back and the light is gone. a minutes work and lexmotto would not tell me this.

Posted by on

Motorcycles Logo

Related Topics:

Related Questions:

2 Answers

Lexmotto ZSB 125 will not turn over


Hi, Mark before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter have failed or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Cold start no power New rider
What Do Check When My Motorcycle Won Start Honda Shadow Forums Shadow...
Lexmoto ZSX 125 Manuals
Lexmoto Motorcycles and Scooters Parts and Accessories Lexmoto Motorcycles...
User Manual Photocopy

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Jul 08, 2017 | Motorcycles

1 Answer

reset maintenance light


Sorry for my bad english!
I try to explane how to reset the EFI lamp:
1. bike in key-on and engine off
2. Near the ECU under the seat there is a 6 way connector (the diagnostic connector), but only 5 way are filled by cables;
3. With an electric cable or other you must connect togheter the 2 pin on the side where there is the hole for exactly 12 sec!
4. After that, the EFI lamp make a series of pulse to indicate the errors occours and then reset the errors memory!
Bie

I copied this from the the aprilia forum (just google it). A good first port of call. In fact, any forum relating to any bike you own is always a great place to start searching

Aug 22, 2014 | Aprilia Pegaso 650 Strada Motorcycles

1 Answer

how to remove the seat on a ybr 125


I don't know this machine but if it is any help on my Yamaha TW125 the seat is held by 2 6mm bolts underneath. The top rail of the sub-frame has 2 small plates that the bolts go thru. Try looking under the seat from the chain side use a torch and you should find the answer I hope. Good luck.

Feb 03, 2014 | 2007 Yamaha Ybr 125

1 Answer

is it easy to remove battery from malaguti phantom max 125


The battery is underneath the rear seat.Lift the driver's seat, remove the two bolts holding the rear passenger seat and you will see the battery.This will help I thinkwww.malagutiscooterspares.co.uk/spares/epcimages/7585/14.jpg

Feb 05, 2012 | 2007 Malaguti Phantom Max 125

2 Answers

how do you shut off the check engine light?


If you are trying to reset the check engine light, you remove the EFI fuse from the engine compartment for about a minute. If there is a problem, it will soon light up again. This is where the EFI fuse is located. As you face the front of the 4Runner, you will see the battery at the front right. The FUSE BOX is just beyond the battery. The top of the fuse box has a panel which identifies each fuse. The EFI fuse is the MIDDLE FUSE, closet to the right fender. If you're talking about the maintenance reminder light reset button, its to the left of the guages, labeled "reset"

Jan 31, 2010 | 1995 Toyota 4Runner

Not finding what you are looking for?

450 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5948 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Loading...