Tip & How-To about 1999 BMW K 1200 LT
Well if your about to change your slave cylinder on one of these beasts..before installing a new slave..bore a small weep hole in the slave cylinder housing (at the bottom of course) you'll need a 6 to 7 inch bit (10mm or smaller) clean out the swarf (pieces of metal left from drilling) from the housing, fit the new slave...this helps if the cylinder should fail again...the dot4 fluid will now run out the weep hole instead of being forced up the push rod....very handy..and remember replace the crush washers on the banjo bolts.
Posted by martin... on
Jun 25, 2018 | Motorcycles
Nov 28, 2013 | 2008 Qlink Legacy 250
Jul 10, 2010 | 1991 Jeep Wrangler
May 18, 2010 | 1995 Ford Ranger Supercab
Feb 20, 2010 | 1995 Saturn Sc