Power Motorcycles - Page 9 - Answered Questions & Fixed Issues

0helpful
1answer

Our 2002 Harley Electra glide looses power while driving down the road, it can sit for a few minutes and the u hear something click under the seat. After that the bike will crank right back up with no

I had a friend with a similar problem. Is the check engine light on? The click might be a faulty relay, but often these aren't loud enough to hear, so it might be something else. Next time it does this, remove the seat and see if you can't identify what piece is clicking. Or if you have a CEL you can try pulling the code to get something definitive.
3/11/2015 3:10:47 AM • Power... • Answered on Mar 11, 2015 • 123 views
0helpful
2answers

I don't seem to have power at the coils, can you help?

Could be loads of things to be honest, Rectifier, Magneto, poor ground the list goes on and on, you need to take it to a shop or test just about everything electrical to do with the ignition section, probably starting with the rectifier.
3/8/2015 9:04:44 PM • Power... • Answered on Mar 08, 2015 • 145 views
0helpful
1answer
0helpful
1answer

2008 street glide no power getting to ignition. Batt and fuses are good.

check regulator rectifier
3/5/2015 11:59:21 PM • Power... • Answered on Mar 05, 2015 • 38 views
0helpful
1answer
0helpful
1answer

Can bad battery cause loss of spark on one cylinder

check coil and rectifier
3/3/2015 6:04:42 PM • Power... • Answered on Mar 03, 2015 • 414 views
0helpful
1answer

Scooter headlight stopped working and bike idling high and sluggish under power

Check the bulb, switch and wire feeding it. As far as sluggish try a tune up. These links may help: Chinese Scooter Parts and Service Manuals Free Repair Manuals For Scooters Scooter Service And Repair Manuals Do it Yourself Scooter Repair Manual
3/2/2015 10:18:13 PM • Power... • Answered on Mar 02, 2015 • 642 views
0helpful
1answer

2014 ultra, after transporting in trailer - will not start, has no power

will it not start, or has no power? Or do you mean power as in electricity? It is very hard to diagnose when such vague questions are used. if it can start and run, but performs poorly, check to see it the spark plug cap hasn't rattled loose, or that the plug isn't cracked or otherwise unserviceable. If you mean it has no electrical power, check the fuses and battery terminals and they may have been knocked out of place.
3/2/2015 3:41:39 PM • Power... • Answered on Mar 02, 2015 • 42 views
0helpful
1answer

1 is there any way to get new NOC once it is lost? 2my battery is good, but indicator not is working? any problems with coil? 3 my bike has low pulling nd power do I need to replace oil or anyt

I'd love to help, but every one of your questions is vague or nonsense. 1. What is NOC? if you mean NO2(or NOS) then you can get it at most car tuning shops or are friends with a Dentist. 2. Which indicator is not working, there are lots of kinds, and since you didn't post your model, I don't even know what indicators you have. 3. Low power is a VERY vague description of performance and could be any number of things depending on model, age, and mileage. if you do use NO2 that is likely the reason for poor performance as it destroys piston rings and scratches up cylinder walls and thus ruins compression. Age and mileage could do this also. additionally since you are asking if you need to replace the oil I can assume that you have never done it since you purchased the bike, which means the damage is likely already done. Oil in virtually every bike ever made needs the oil changed every three months of riding, or twice a year if not riding often. One inexpensive thing you can try is changing the spark plug(s), if they/it is old it could cause weak ignition and thus lower power output. my recommendation is with as many issues as you are having is that you take it to a shop for a full check-up. hope that helped.
3/2/2015 3:34:59 PM • Power... • Answered on Mar 02, 2015 • 71 views
0helpful
1answer

Why intermittent spark at plug

condenser is bad
2/26/2015 4:40:33 PM • Power... • Answered on Feb 26, 2015 • 99 views
0helpful
1answer

How can i get a power cord for my Swinn ex. bike?Estimated to be 5 Years old.

It would help to know what model bike You have because that model number can be given to any appliance parts dealer that You find locally, possibly even Sears, to get a replacement power adapter. I'm assuming Yours is like a small transformer that plugs into the wall outlet with a small cord that has a shiny metal pin on the end that plugs into Your Bike? Adapters for other Schwinn® and Nautilus® home fitness equipment can be ordered by phone at (800) 605-3369. Optional power adapter for the Schwinn® A40 elliptical, A10 and A15 upright bikes and A20 and A25 recumbent bikes. I hope that helps!
2/19/2015 5:12:06 PM • Power... • Answered on Feb 19, 2015 • 185 views
0helpful
1answer

My 1989 rm 250 bogs out when I'm half to full throttle it does fine has plenty of power but half to quarter throttle it dies unless I just keep reving..cleaned the carb and adjusted the idle & it stil

Depending on the type of carb you have you can change metering rods or orifice in the low speed jetting.
2/18/2015 8:14:02 AM • Power... • Answered on Feb 18, 2015 • 264 views
0helpful
1answer

How can I find a complete power rider manual to print?

Really dude? I googled it. Here's a link to one. http://hi.atgimg.com/pdf/4579/powerrider_man_us_130913.pdf
2/17/2015 7:57:51 AM • Power... • Answered on Feb 17, 2015 • 28 views
0helpful
1answer

I have an 1982 sportster 1000 that only fires when it wants to. Where should I start diagnosing it? It does have power to the coil right now, but sometimes it doesnt.

Find out what your coil voltage is and tests and see if you're getting the right amount of voltage to the coil and from the coil when it's on and if you're going to need it when it's off the first thing you need is a wiring schematic for 1982 sportster or you could just replace the wires if there be original wires and the coil packs if the be
2/15/2015 12:29:50 AM • Power... • Answered on Feb 15, 2015 • 102 views
0helpful
1answer

My quad as no more power when hot

A partially plugged exhaust will cause it to overheat and lose power. When it stalls, do you still have spark? An ignition coil may fail hot, look for a crack in the plastic.
2/14/2015 3:46:07 AM • Power... • Answered on Feb 14, 2015 • 88 views
0helpful
1answer

Hello, I have no spark at the plugs of my 1982 Rd350Lc Yamaha, I have checked all the connections, but there is no power at the LT or HT leads of the coil when you turn the motor over.

Your bike is something of a classic and you could find more specialised information on an appropriate bike forum. Presumably it has an ignition module of some sort and with the aid of a wiring diagram all the cables and voltages and connections to and from it should be checked for cleanliness, continuity and power as appropriate. The module connections on my CX500 had corroded and needed a thorough clean.
2/12/2015 7:26:05 AM • Power... • Answered on Feb 12, 2015 • 261 views
0helpful
1answer

I have a kinlon 200rt 2009 model and the bike has no power wont start at all please help

Dead battery. Recharge or get a new one.
2/4/2015 10:34:40 AM • Power... • Answered on Feb 04, 2015 • 43 views
0helpful
1answer

My bikehas power but battery wont start bike

What's the make, model and year? It may be as simple as a low charge on the battery. If it has been sitting a while then the battery may have enough juice to power the lights and instruments, but it may not supply enough power to the starter which requires a lot of amperage. Most parts stores will test your battery for free. I had a Yamaha Vstar Classic which has a starter clutch issue where the starter becomes jammed and requires pretty serious surgery to repair.
4/19/2016 11:00:59 PM • Power... • Answered on Apr 19, 2016 • 88 views
0helpful
1answer

My samsung sm-t210r

You need a new battery if it wont power up it means the battery wont take/hold charge
1/3/2015 9:43:32 PM • Power... • Answered on Jan 03, 2015 • 63 views
0helpful
2answers

My 2003 xlt 1200 wave runner will not do anything when the start button is pushed. There is power going into the computer but not any power coming out. Does the start button go straight to the compute

Is your battery fully charged? If you have two wave runners, switch the computer from one to the other and try again.
12/29/2014 5:18:45 PM • Power... • Answered on Dec 29, 2014 • 172 views
Not finding what you are looking for?
Power Logo

Ask a Question

Usually answered in minutes!

Top Power Experts

Brad Brown

Level 3 Expert

19187 Answers

NOEL
NOEL

Level 3 Expert

8606 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Power Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...