20 Most Recent
2001 Suzuki GSX-R 600 - Page 3 Questions & Answers
2003 SUZUKI GSXR 600 SHIFTING QUESTION
The transmission on your bike is not syncronized like a cars trans. When you are trying to shift from neutral at speed you must slow down to allow the gears to mesh. As far as having to rock the bike into gear sometimes, I have owned eighteen motorcycles of different sizes and makes and have had to rock all of them at one time or another to get them in gear. again lack of syncronization. It really doesn't sound as if you have a problem.
bigc
Hi, I have a 2001 suzuki gsxr 600 and it sometimes
You need to have your gear box checked, it might be a press or clutch but it needs to be opened to sort out this problem.To start try to see if you can increase the tension of the clutch and if not lucky then you have no other choice but to open the gear box.
How do I check the STVA on my gsxr 600 K1 as code
It is indicating a mismatch with either the secondary butterfly, the actuator or the sensor. The easy fix is to buy a second-hand throttle body from a wrecker and install that. The long and expensive answer is to buy a new TB ($1000, near enough). Alternatively, 'fix' the secondary butterfly in the open position and live with it.
Bike cuts out after 15secs
Hi,
The F1 display is an indication that one or more of your sensors are indicating a fault. Your bike is equipped with an ECM module that records and stores all fault issues. Unfortunately, only dealers and bike repair shops have the special readers to diagnose your issue. If you take it to a bike repair shop, ask to make sure they have the reader. Otherwise, it could cost you more in the long run by them trying to track it down by trial and error.
I wish I had a quick fix for you, but it looks like a trip to the dealer is in order.
Hope this helps
Shift rod is pushing on the case cover
PULL IT ALL DOWN AND TRY PUSHING IT AGAIN, SEE WHERE THE PRESSURE IS, Noit sure what the soloution is mate, but might need a strip down on the clutch cover side as well, oil drained and have a look whats going on.
What is leaking on 02 gsx 600 near the broken sproket cover
there is a oil seal behind the front sprocket that may be damaged.Also the case may be crack due to chaine impact. This type of damage is common when chaine is not kept to spec..If case are crack you can repair with jb weld no oil pressure at this location. Have to be clean and scuff for product to work properly.Mr cee's cycle Repair.
Why would my turn signals stay on my 08 Street glide
You may have some bulbs with burned out filaments, Or the bulbs may not be in correctly. Pry off the lens cover with a dime and inspect the bulbs. Make sure they have two filaments. If one filament is broken, replace it with a new bulb. Bulb #1157
Doesn't start when its hot
That could be fuel related or electrical related.
Without more details its hard to give advice.
If you have an aftermarket fuel controller dis-connect it and use the factory controller. If that fixes it your controller has a problem. If you have a factory controller it may also have failed. Could also be a fuel pressure issue, bad pump.
Best the have the dealer pull the codes to find out exactly what has failed.
Not finding what you are looking for?