20 Most Recent 1997 Suzuki GSX 750 F (Katana) Questions & Answers

Do not put oil in the brake master cylinder! Only DOT 4 or DOT 5 brake fluid should go in the master cylinder! The proper fluid should be listed on the top cover of the master cylinder. Brake fluid will have absolutely nothing to do with your valve leak.

sounds like tank vent is clogged

If you have a test light, Put alagator clip on ground side of horn. Touch other side with light on hot side. Then push horn button. If it dosen't light up It's the horn button thats your Problum. Hope this helps.

Online
http://www.oldbikebarn.com/Street/1997-Suzuki-GSX750-F-Katana

If you need one local,Give me your City,State,Zipcode(Not your address)

Please rate this Fixya

Good possibility, You can check the out put voltage of the pickup coil. This has to be done with a "peak reading volt meter". There are some commercially available adaptors to insert in a standard volt meter for this check. With adapter installed, meter set to DC volts the reading across the leads from the pick up coil should be 3-7 volts at cranking speed. You should also confirm that you have battery voltage with the key & engine stop switch on at the cdi box as well as a good ground. I believe on a Suzuki this will be the orange/ white for battery voltage and the black will need to have contininity to ground. Also the orange/white at each coil should have battery voltage with key and engine stop switch on.

Change your coil

Does this motorcycle have a radiator if so, make sure it's full if it is go online and see if there's a sensor that shuts the bike down when it gets too hot. Maybe there's something wrong with that

compresion tsest could be a slightly bent valve, or valve too tight, inlet side.

bad fuel ? clean out carby and filter then if no spark at the plugs start at coil

https://www.youtube.com/watch?v=rRQ45lT2d3c I would check the coils, leads and plug cap. Check the video to see how.

Hi Oscar follow the loom carrying the three yellow wires from the generator on the left hand side of the motor. These will lead you to the reg. it is an aluminium box with cooling fins on it. Usually under the left hand side cover. Regards Jim...

easy mate, get an old screw driver a thin one heat the end up cherry red, bend over the las 5 mm cool it and put into seal and gently move round and pull out clean area tap new seal in with deep socket right way round, make sure you see how it came out