20 Most Recent
2008 kawasaki Ninja 250R - Page 7 Questions & Answers
I have a 2007 Ninja 250F. When I give throttle it
Check and if necessary replace your air filter. You will find it, just follow your intake from your motor back (or check your manual for location). If this has happened after the bike has sat unridden for a while it may be a fuel related restriction.
Hi my suzuki gs500 is hard to get in 2nd gear in
This sounds like a slightly bent shift fork. Extremely dirty gearbox oil can also cause the problem, so I suggest you start there. The fork replacement is very costly. Have a dealer look at it if changing oil doesn't help. Get their opinion first hand and get a quote on repair costs.
My gas meter is never right
You can ohm the tank sender and see if its changing resistance as it should when the tank level changes. You could test it when filling or just tip the bike a bit to look for changes.
If it isn't changing with level change....replace!
Good luck and be careful!
There is a buzzer sound when I try to start my
Hi and wlecom to Fixya.
The starter is probably making the buzzing sound. This can be caused by low battery power / low battery water / loose battery terminals / bad start relay / worn brushes in the starter / bad starter solenoid. In other words there are many things to check....
You can try using jumper cables to see if the starter works normally. If it does then you need to find out what is wrong with your battery or charging system.
If it does not start... see the list above.
Kelly
Bike sounds funny on highway and is not as fast as it once was
have a good look at the clutch i bet its slipping like mad
you need some free play on the clutch or when the engine gets hot it slips,,,,and then it burns out and then it costs you a lot to fix it up again,, that,s were your
"get up and go " went,, it "got up and left" along with your cash to fix it,,,
I need to replace my chain and sprockets for new
You can remove the existing chain and thn measure it, thn buy a new one with a little + side coz the sprockets will be new also, and well there is always allowance for adjustments on the bike's swinging arm.
Hope this helps!
Only runs on one cylinder
check the compression of the cylinders first to make sure the top end is not blown, if all goes well then proceed to see if the spark plugs are good, this can be done by looking to see of the plug is soaked and smells of gas, if that is the case then the plug is fouled which would cause on cylinder only to fire, also make sure both ignition coil wires have spark,
Would the fairing parts of a 2006 kawasaki ninja
Yes I do believe they do. Try going to Powersportseast.com Look in the shopping section on the left of the homepage. You will want to use the parts fische and load the info for your bike. It allows you to see what the dealer parts counter can see. See if this helps. I'm pretty sure the 250 ninja really didn't change until 2008 when it got the BIG overhaul
What kind of plug use to ninja 250 r
Consult the owners manual if available for your model yer if possible, but NGK CR7HS sounds about right, I do not suggest getting motorcycle parts at an autoparts store, This is one time where one should always go to the dealer. Don't know where you are located, if its unusually warm or cold weather the dealer might suggest a slightly colder or hotter heat range on the spark plug. Always gap and torque your plugs to facotry specs!
My personal experience is the NGK plugs work best in Kawasaki motorcycles. Tried others and always go back.
Every wire is unplugged on my kawasaki ninja X7
May I suggest a trip to your local library. Cycle repair books should be in 646 stacks of reference. Otherwise, go to your Kaw dealer and pay their price for one that covers your bike. You'll still pay less than if you paid them to rewire it...and you'll learn something.
I have a starting problem on my 99 220 bayou it
if your popping the solenoid on the starter. then it is wore out or seizing up. i think it's time to replace the starter. i had that same problem with a 1987 monticarlo that had headers heating up the starter. so i did the screwdriver starting bit and it was not fun.
Not finding what you are looking for?