Top 20
2007 kawasaki KX 125 Questions & Answers
My clutch basket came loose
as i striped it
Sounds like they were put in in the wrong place.. swap them..tighten with an air tool...the washer with the splines goes between the basket and the inner hub..the big washer goes behind the clutch basket.(goes on the shaft first)
Top speed
no you **** going bigger in the back is more accel, smaller is more top end. a 48-46 would put you somewhere between 80-100 mph depending on the engine but result is **** low end. If your kx is 6 spd you would benefit from going up a tooth or 2 for lowend because it has topend already.
1993 ninja no power under load
could be the float , clean carb again . if it was me id check the compression , easy stuff first . then check the spark output to know if your getting weak spark after its warmed up . the service manual explains how to check the electrical system.
Removing gear lever Kawasaki KX 125
Does it have a pinch bolt? If so undo and remove the pinch bolt, if the lever doesn't slide off you will need to pry the pinch part of the lever apart. It should then slide off. If it is worn it will hang loose, you will need a new lever, also check the splines on the shaft.
Witch way do the grooves go on clutch on 87 kx125
Instructions
-
Street Motorcycles
-
1
Mount your Ninja or Eliminator motorcycle and lift it off of
the kickstand. Insert the key into the ignition and turn it to the "ON"
position.
-
2
Reach down to the base of the fuel tank with your left hand
and turn the fuel valve, or petcock, to the "ON" position. This will
place the fuel valve lever in the 6 o'clock position.
-
3
Place the engine kill switch on the right handlebar into the "RUN" position.
-
4
Pull in the clutch lever and depress the starter button on the right handlebar to start the motor.
2006 xk125 parts list
Are you looking for a parts list? Try web site for Cornwall Kawasaki, motocross spares.
Not finding what you are looking for?