20 Most Recent
2007 kawasaki Eliminator 125 Questions & Answers
I have a 2001 kawasaki 125 eliminator shuts off
If it dies when put into gear then its the side-stand switch (stand is down or switch not working)
If it dies when the clutch lever is released then either it was released too quickly with not enough revs, the engine doesnt have enough power to pull away or possibly the clutch switch is working in reverse
Good Luck
Hope this helps.
(If it does then please mark this as 'useful')
Ride Safe
Bike-Doc
Pano ba mag tune up
Intake: .003-.005"Exhaust: .006-.008''ano po ba ibig sabihin nito? mean Intake:.003 at Exhaust:.006"
How do you change the oil for a 2007 Kawasaki
There is a single bolt on the bottom left center case half. Remove the drain bolt to drain the old oil. Use 10w40 motor oil. NEVER use synthetics or oils with " Special " additives. Synthetics etc., can mess up the friction plates in the clutch. Please rate my answer. Thanks.
2002 125cc Kawasaki Eliminator
There is no dip stick, put your bike on a flat even surface and with it straight up on the r/h side engine cover towards the bottom rear there is a sight glass window, you want the oil level to the top of the window, that’s why it crucial that the bike in on even ground and straight up to get an accurate measurement.
Hi there. I have an Eliminator 125, 2007 model.
More times than not they are 10mm but sometimes are 8mm. 10mm is the most common size from motorcycle to dirtbike.Call the dealer they should know.What I do is find a local dealer that offers a Parts Fische on thier web site. I use Power Sports East, or Diamond Motorsports. They both have Parts Fische that you can use.
Gas milage
I consistently get about 75mpg on my 2001 model over the past 7 years. Since the 124 hasn't changed much since 2001, the 2008/2009 models should get about the same.
Not finding what you are looking for?