20 Most Recent 2005 kawasaki KX 125 - Page 2 Questions & Answers

adjust the shocks to suit your weight and riding style

for kx125, that kind of problem i kind of remember my friend just like that too. so clean everything inside . so u have to changes the valves and also the lifter then do the piston pin too,.also chick the rod if in good! that's it for now then when u do that tell me what going on!

clean air filter, spark plug and change oil, adjust valves if possible or noisy, done!

check your carb float pin.

If you own a KX125, you need to own a factory service manual!!

clutch plates are shot and probably the springs too

This sounds like the crankshaft seal is leaking

that would be a good reason it wont fit

could be the float , clean carb again . if it was me id check the compression , easy stuff first . then check the spark output to know if your getting weak spark after its warmed up . the service manual explains how to check the electrical system.

start by checking your oil level

Does it have a pinch bolt? If so undo and remove the pinch bolt, if the lever doesn't slide off you will need to pry the pinch part of the lever apart. It should then slide off. If it is worn it will hang loose, you will need a new lever, also check the splines on the shaft.

most are in tight and 1 and 3/4 out

try acompany call new level motorsports in the states

Instructions

1. Street Motorcycles
   • 1 Mount your Ninja or Eliminator motorcycle and lift it off of the kickstand. Insert the key into the ignition and turn it to the "ON" position.
   • 2 Reach down to the base of the fuel tank with your left hand and turn the fuel valve, or petcock, to the "ON" position. This will place the fuel valve lever in the 6 o'clock position.
   • 3 Place the engine kill switch on the right handlebar into the "RUN" position.
   • 4 Pull in the clutch lever and depress the starter button on the right handlebar to start the motor.

Are you looking for a parts list? Try web site for Cornwall Kawasaki, motocross spares.

the clutch is slippn--inspect that area-probly just need ajust or a rebuild

32-1