20 Most Recent 2004 kawasaki VN 750 Vulcan Questions & Answers


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=2004+Kawasaki+VN+750+Vulcan+fuel+line+routing&tbm=isch&source=univ&sa=X&ved=2ahUKEwjzqeCiqsDgAhVMpFkKHbugBvsQsAR6BAgAEAE&biw=1440&bih=757
https://www.vn750.com/forum/22-carbs-fuel-system/17301-fuel-line-routing.html
https://www.manualslib.com/manual/1205664/Kawasaki-Vn-750.html
https://www.partsfish.com/page/oem-parts-for-kawasaki
https://ownersmanuals2.com/kawasaki/vulcan-750-2004-owners-manual-68884

2004 kawasaki VN... | Answered on Feb 16, 2019


Hi, Ewhite5765 for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Oil Type Kawasaki Vulcan 750 Forum Kawasaki VN750 Forums
How to change motorcycle oil Kawasaki Vulcan
https://www.vulcanrider.se/en/kawasaki-vulcan-service-manuals OEM Parts for Kawasaki
2004 Kawasaki Vulcan 750 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2004 kawasaki VN... | Answered on Mar 15, 2018


Hi, Jesonyx external oil deposits fall into 3 categories:
1. WEEPAGE is oil that is sweated pass gaskets, seals, o-rings, and crankcase seams, it's covered by dry dust and is normal for older engines with lots of miles, no repair is necessary.
2. SEEPAGE is the same as weepage except the deposit is wet and confines itself to a specific area, repair is optional depending on the owner's cleanliness criteria, the deposit location and the weight of his bag of "DRACHMA"
3. LEAKAGE is the same as seepage except it is enough to drop to the ground leaving a spot. Repair as necessary.
To find the source of your oil leak, start at the point where you see oil and trace its path going up and forward, blowing baby powder from the palm of your hand will help in those difficult to see areas if there is too much oil present then buy a spray can of engine degreaser apply it to the affected area then rinse off with a pressure wand or garden hose, use compressed air to blow off excess water or just let it drip dry, take your bike for a 15 minute ride and check for the leak.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.vn750.com/forum/11-vn750-general-discussion/20399-oil-leaks-shifter.html
2004 Kawasaki VN750 Vulcan shifter oil leak Google Search
https://www.vulcanrider.se/en/kawasaki-vulcan-service-manuals OEM Parts for Kawasaki
2004 Kawasaki Vulcan 750 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2004 kawasaki VN... | Answered on Mar 14, 2018


Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere $20 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
cam chain noise Kawasaki Vulcan 750 Forum Kawasaki VN750 Forums
cam chain noise Kawasaki Vulcan Forum Vulcan Forums
Kawasaki Vulcan 750 VN750 Twin Motorcycle Complete Workshop Service Repair... $20
OEM Parts for Kawasaki
2004 Kawasaki Vulcan 750 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2004 kawasaki VN... | Answered on Mar 13, 2018


Intermittent faults are difficult to locate and occasionally the cause is never found. Often the problem cures itself or somebody cures it by desperate and mindless fiddling but doesn't know how.

I tell my customers to persevere and eventually a pattern will emerge - the same corner, the same stretch of road, the same sort of weather, the same speed, the same gear, etc.. Once a pattern is recognised it increases the chances the problem can be repeated predictably or some serious detective work might provide further clues.

Fitting temporary telltale lights to monitor supplies and grounds around the circuit can be helpful.

I have had two cars where the intermittent fault was inside the ECU. Very difficult to prove and too expensive to replace without justification. On one car I was lucky and had a timing light connected when the fault happened. I watched the timing mark move and keep moving until it was almost out of sight and the engine stopped. It restarted immediately and ran normally until the next time.

2004 kawasaki VN... | Answered on Sep 30, 2017


I believe there are a couple of bolts inside the "toolbox" in the backrest that need to be removed before the seat will come off.

2004 kawasaki VN... | Answered on Jun 22, 2014


sounds like a temp. sensor malfunction.

2004 kawasaki VN... | Answered on Jun 23, 2013


An engine is an engine, whether a car or a bike engine. Synthetic engine definitely is better for all engines. Better lubrication, longer life, longer time between oil changes thus more savings on servicing charges etc. Go ahead.

2004 kawasaki VN... | Answered on Aug 05, 2011


The speedo's are 100% mechanical. If there is no cable conencted to your speedo, you found your problem. The cables are prone to break right where they make the turn to head up to the speedo from the wheel sender. A new cable is about $20 dollars and is easy to replace.
I hope this helps.

2004 kawasaki VN... | Answered on Jul 02, 2011


Behind the left engine cover. The engine must be almost completely removed to change it out.

2004 kawasaki VN... | Answered on Nov 28, 2010


could be faulty oil pressure switch

2004 kawasaki VN... | Answered on May 20, 2010


Have you tried to talk to your Kawasaki dealer or go to Haynes website to look for your repair manual. Well mate, in this world nothing is free anymore even the air is getting pretty close to be charged for carbon foot print tax. Good luck

2004 kawasaki VN... | Answered on Mar 15, 2010


you must have a fault with the sensor buddy replace this or the connections are not in correctly or is this the oil pressure light

2004 kawasaki VN... | Answered on Sep 05, 2009


I would check the fuel flow and the timing to make sure that your not getting to much fuel and that you are getting spark at the correct time.

2004 kawasaki VN... | Answered on Aug 30, 2009


one of two thing's comes to mind, either inside the Headlamp,(or) under the gas tank, you either have a loose wire, or a blown fuse, I suggest trying the "headlamp" first since it takes a hell of a beating, going down the road, please let me know if this got ya setor not, god bless, and safe riding

2004 kawasaki VN... | Answered on Jul 06, 2009


The value is probably $100.00. The bike is worthless if you can't get parts. When was the last time you saw a "Baotian" dealership in the USA? Whoever buys it will likely be highly dissatisfied when they find no one will ( or can ) service the bike.

2004 kawasaki VN... | Answered on Jun 08, 2009


thats normal there is usually alot of play

2004 kawasaki VN... | Answered on May 15, 2009


dear sharil you havent gave to much info about your heating problem. the most common cause for this prblem would a stuck thermostate,or a bad waterpump. but iwould replace thermostate first. not a big job but just a small warning after replacing thermostate and replacing antifreeze be sure to bleed air from system. a little bleed screw is located near the thermostate housing for this purpose

2004 kawasaki VN... | Answered on Mar 26, 2009


if you plan to modify your exhaust system you will have to rejet your carbs to compansate. kits are availableat most aftermarket shops.

2004 kawasaki VN... | Answered on Mar 24, 2009


Hi, H for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Cylinder Timing Kawasaki Vulcan 750 Forum Kawasaki VN750 Forums
1983 Kawasaki VN750 Vulcan timing specs Google Search
Kawasaki VN 750 Service Manual
OEM Parts for Kawasaki
1989 Kawasaki Vulcan 750 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

kawasaki VN 750... | Answered on Mar 15, 2018

Not finding what you are looking for?
2004 kawasaki VN 750 Vulcan Logo

26 questions posted

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5809 Answers

Marvin
Marvin

Level 3 Expert

84027 Answers

richard libby

Level 2 Expert

202 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

VN 750 Vulcan kawasaki

  • VN 750 Vulcan kawasaki

Most Popular Question

fuel lines diagram vulcan 750

  • Motorcycles
Loading...