Top 20
2004 Honda CBR 125 R Questions & Answers
I have a 2007 zx6r and it runs fine but the f1 light is flashing but as soon as you try to put it in gear it cuts out
Hi. There ae numerous forums/site for your bike's FI codes. Since I don't know what code your FI is flashing, all I can say is put the FI code into your computer google or yahoo search area, and you will get an answer. Yiur FI should flash a few times first, and that is the first digit in the sequence. A second later, it should flash again, and that is th 2nd digit in the code. an EXAMPLE is 2 flashes, pause, 3 flashes...then repeats. That will be a code 23. Trust me, you will find the FI code online. Good luck!
Electric start doesnt seem to be working
If there's no noise at all your battery is either dead (jump start or new battery). If it clicks then there isn't enough charge in your battery to start the bike (charge battery or bump start)
Coolant leak
you have over filled it and there is air in the coolant system ..run bike with therostat cap off ensure all air ais gone top up ..should be sorted
How do i fit a clutch cable to a honda cbr 125?
The clutch cable is fitted to the lever and the clutch arm on the top of the crank case beside the oil cap. Remove old cable (remove side fairing if you need to for access to cable end) slacken the new cable adjusters as much as possible fit to the clucth arm on the engine and fit to its seat route the cable the same as the old one up to the clutch lever, fit the cable end to the lever, hold the cable sleve tight pull the lever to strech the cable and drop into the lever seat, adjust the cable for 2mm of free play at the lever before the cable is pulled
Petrol is leaking when start the bike
Float in carb prob sticking or filter in float blocked,worth taking a look yourself,I have one and had same problem,bit of grime in it,once cleaned was fine
Bike been stood for 6
The problem may be the petrol. Usually after 3 months, the petrol itself in the carburettors tends to evaporate and leave behind the additives. These act as a gum and block up everything including the jets !! Apart from the gum, the petrol now fails to ignite - DO NOT TEST THIS LAST PART OUT, just accept that it may be. Firstly, drain the petrol from the carb. and change the petrol in the tank. Prime the carb (with a few twists of the throttle) and try it again. If your lucky, enough will get through to ignite, once it's running, you can then drop in a few cc of something like redex and clean the carbs while running. If the petrol doesn't ignite then I'm afraid its a carb clean. Get a haynes manual and look first before stripping the carbs down. Not difficult to do.
Just put a motad venom
Contact motad for a recommendation if you have put the correct exhaust for your bike.
The tuning maybe slightly different but it should not be wildly out.
---
Please dont forget to vote this answer was helpful
Many thanks
------
I tried to start my
starter soleniod is stuck, rape on it ,or fuse is blown..or it could be a stuck push start switch when you depressthe switch does the headlight go out ? if it does then this is normal operation
Hi, me and a friend put my bike through a service
So take off the K&N filter and run down the street with out any filter. If the problem disappears you know the filter is the problem. In my opinion, K&N filters are over-rated. If the problem is still there, install another new spark plug and drain the float bowl on the carb. The first plug may be fouled or feathered. The bowl may have accumulated enough condensation from the gas tank to cause a problem. If so, the serviceing you did had nothing to do with the problem.
Had a small leak in the radiator of my CBR 125.
take ya left fairings off ( Ball ache) then theres a small screw on the radiator cap undo that and fill it from there. if its been leaking id suggest i little bit of k seal or rad weld in it just to be safe. and top up your reserve tank. thats under your seat. just pop the back seat n its a screw in the back to get it up
My honda cbr 125 wont start. Battery okay
i think youneed to start the bike with a fully charged battery and the choke open with no throttle and keep turning it over till it stars failing that check the fuel hoses and vacum hoses to the carb
What oil do i put in my honda cbr 125?
I believe the manual calls for 10w40 GN4 Honda oil. Any 10w40 motorcycle oil should be okay. I run Shell Rotella T 5w40 synthetic in both of my bikes and it seems to work very well. Stay away from the car oils with the "energy conserving" labels as the can cause the clutch to slip.
Hope this helps.
Bob
Not finding what you are looking for?