1993 Harley Davidson FLSTF Fat boy - Answered Questions & Fixed issues
The thickness of bottom end crankcase on evo engine @
Hi, Gary the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and enquire about any possible quick fix, answers, or parts enquiry.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at
[email protected]. Good luck and have a wonderful day.
12/2/2020 8:18:33 PM •
1993 Harley...
•
Answered
on Dec 02, 2020
•
213 views
How can I tell if my voltage regulator is working properly?
Hi Tom, the video is pretty good. but you can check another way.
Access your battery and start the engine, set your meter to DC 20 volt range if possible if not just DC volts. Connect the meter across the battery terminals if your reg/rectifier is working OK you should get about 13.5 volts at idle this should increase to about 14.5 volts at 4 to 5,000 rpm. In other words as you increase the revs from idle the voltage across the battery should increase until the regulator cuts in at which point the volts should remain fairly stable. Hope this helps and good luck..
6/9/2015 10:10:58 AM •
1993 Harley...
•
Answered
on Jun 09, 2015
•
974 views
Why won't it start?
I'd look for a major fuse, switch, Relay Melted wires or insulation. So the battery drained overnight? Which indicates a bad short somewhere. I like to use the new led bright flashlight to do a through inspection of the wiring system in the dark.
6/8/2015 3:27:46 PM •
1993 Harley...
•
Answered
on Jun 08, 2015
•
162 views
Why 1992harley pumps oil when cranking over to star
Check your oil tank level. If it is empty or very low, the oil has seeped by the oil pump check valve and has filled the engine cases with oil. I assume the oil is coming out the air cleaner breather tube? If so, add a quart or so to the oil tank, run the breather hose into a can or bottle, and start it up. Oil will flow out the breather until the cases have been purged. When it stops pumping out refill the oil tank to the proper level. This can happen when the bike has been sitting for a few months or more.
3/12/2015 9:22:30 AM •
1993 Harley...
•
Answered
on Mar 12, 2015
•
255 views
Starter removal 1998 fatboy
Starter motors are found on the engine ....normally they are metal and cylindrical in shape ....locate yours by looking at the images of your models starter online.....
Removal instructions
1# disconnect your battery
2# disconnect the starter connection wires ,,negative and positive from the starter motor itself.....
3# unbolt your starter motor ....
And repeat these steps in reverse to fit your new starter
10/19/2014 11:13:54 AM •
1993 Harley...
•
Answered
on Oct 19, 2014
•
1,125 views
93 harley battery wont hold a charge
battery could be no good so have it charged and load tested and then you may have a key off abnormal drain on the battery due to a shorted regulator or accessorizes. Remove the main fuse to see if it still drains and if so something that should not be key off draining is the probelm amd if the battery still goes flat you need a new battery most likely.
10/18/2014 5:35:31 AM •
1993 Harley...
•
Answered
on Oct 18, 2014
•
180 views
Remove seat fatboy
Sorry you have not had an answer yet, I also do not have the expertise for that vintage. Please post a comment when you get an answer so others will get that knowledge.
10/17/2014 9:51:22 PM •
1993 Harley...
•
Answered
on Oct 17, 2014
•
647 views
Not finding what you are looking for?