2001 Kymco Stryker 125 - Answered Questions & Fixed issues

clean the carb,check spark plug and air filter

There is one fuse and it is where the battery bracket is holding the battery in

there are different methods of restricting, hear we 1. gasket between the carb and inlet. ". gasket between the exhaust and head, 3. washer in the output sprocket to drive to wheal in the centrifugal clutch Re: Jeff

check the switch on the stand may not be opening. normally if you leave the stand down it will cut the engine when you put it in gear, its a safety switch.

its a 4 stroke machine

if you remove the pipe to the air filter box you can measure it, but if you fit a K&N filter you will have to re-jet the carb, or it will not run properly

http://www.epfguzzi.com/kymcobiz/service/index.html gives a picture of parts needed for fuel system..manual free to view

http://www.epfguzzi.com/kymcobiz/service/index.html had a manual on your bike. Also gives part numbers and places to order part. Manual will give you a clue to the type Carb that was on there so you can find one to fit.

i need to replace my starter motor for my kymco stryker. do you know any omcpatible parts that is exactly th same as my kymco stryker

hmm i dont think its possible the only way to do it is hot wire the bike or by a new ignition barrel which will come with new keys

from the dealer the have the dulpicate.

Take the engine out and completely disassemble the engine and cases as the cases need to be split to get crankshaft out... You will want someone to help you that has more experience, as it sounds like you don't have a lot.. Not saying it's a bad thing but when it is this serious help is good...

Need to know what parts to take off to get to a crankshaft on a moped 2000 2T 50?

Check the kill switches including the side stand switch, with an Ohmmeter. Check the fuses. Check the wiring harness. Are all wires clean and with a solid connection? Any abraded wires? Check the operation of the ignition switch with a volt ohmmeter. Is the bike in neutral and the neutral light is lit up?

If still no spark, get CDI system and coils checked at the dealers shop.

Please rate this answer. Thanks!

get a manual for it and then you will be able to do any thing you have to do , when the time comes.

hi m8 dont know about the manual but if u go to ebay.com and tape in kymco stryker they have loads of engine parts hope this helps m8.. will g..

You probably need a new clutch. That can explain why it bogs. The smoke I don't know.

did you replace the whole indictator assemblies or the bulbs and are they l.e.d indicators you have on it now and was it using l.e.d ones originally

Bad ground. Find the fault and fix it.

Try changing the spark plug first and clean the air filter.