Top 20
2004 Cagiva Mito 125 Evoluzione Questions & Answers
My bike battery doesnt recieve a charge at all
http://www.oemmotorparts.com/oem5.asp?M=Cagiva&T=MITO EVOL.125&Y=2003&L=CA-MITO-4&O=FLYWHEEL -STARTING MOTOR&F=CA-MITO-4_AU&L2=CA-MITO-4_AU
This website has the parts, maybe. check voltage regulator first to make
sure that is putting out voltage, and if it is not check magnito for output
going to regulator, if it is not putting out then this is where your problem
lies. you can fix it yourself, but best to take it too the dealer and let
them run dianostic ... this maybe a cheaper way to go.
I Have 2013 350 raptor wont start. Replaced ignition coil and ici box and spark plug.. No spark. Still wont turn over
You have written some conflicting information. How can you know that your engine has no spark if it will not turn over? No problem, please write back and elaborate on its issue, symptoms, engine codes and things you have checked and tested so far. At this point I would start looking around. Inspect the battery and power distribution box. Check that the battery connections are clean and tight. Check that the ground cable, going to the body panel is clean and tight. Check all the fuses for damage (over heating or corrosion) and the same for the relays. Is the antitheft system working (does it recognize your ignition key?)? When you turn the ignition hey to the RUN position. Does the gauge cluster respond like it always does? Do you see the lights come on and go out and can you read the odometer mileage? Please write back and let me know. Good Luck.
9/20/2018 12:58:59 AM •
Cagiva...
•
65 views • 0 helpful votes
How do you set up timing on a cagiva river 600
Remove the side cover so you can have access to the stator. Then you will be looking for a notch on the inner case. Once you locate the notch you will line up the stator ( which also has a little line or notch on it ) with that notch.
10/19/2016 6:45:30 PM •
Cagiva...
•
304 views • 2 helpful votes
I need to replace the left tail fairing and I need to know if I can use one from an older model
Possibly depends if your model is still being made or find out if not when the style and looks changed after your year an usually you find bits like fairings exhausts etc are interchangeable from earlier models but not to disshearten you but being cagiva or aprillia you need the same year or atleast model from when it was started until next model changed hope it helps pal
1/14/2014 11:04:24 PM •
Cagiva...
•
84 views • 1 helpful votes
Dies when put in gear
Check the kickstand interlock switch. As deemed mandatory by the DOT.. all street legal motorcycles come with a switch in the kickstand pivot area that detects whether or not it is in the upright (or down) position. This is supposed to prevent riders from taking off with the kickstand down, which can ruin your day when the first left hander comes up- This switch will essentially shutdown the electrics to the engine once you attempt to engage first gear (in the down position)...These switches are fairly reliable but can fail. To test it, take a small jumper wire and connect the two wires (going to the switch) together.
1/10/2014 1:03:14 PM •
Cagiva...
•
61 views • 0 helpful votes
Need circuit diagram for ARLEC 15e 6-24Volt 15Amp Electronic battery charger OR their later model BC58
I can't find a diagram.
The small potentiometer on the control board likely serves as an adjustable component to fine-tune specific parameters. Here are some possibilities:
Voltage Regulation:
The potentiometer might control the output voltage. By adjusting it, you can set the desired charging voltage for different battery types (e.g., 6V or 12V).
Current Limit Adjustment:
It could be used to set the maximum charging current. Adjusting the potentiometer allows you to limit the charging current based on the battery's capacity and condition.
Sensitivity or Threshold:
Some potentiometers act as sensitivity controls. For example, it might adjust the threshold at which the charger switches between charging and maintenance modes.
Setting the Potentiometer:
Without the specific circuit diagram or detailed information about your charger, I recommend the following general steps:
Observe the Potentiometer:
Identify the potentiometer on the control board. Note its position and any markings (if present).
Consult the User Manual:
Check the user manual or operating instructions. It might provide guidance on adjusting the potentiometer.
Trial and Error:
If no specific instructions are available, start with the potentiometer set to its mid-position.
Gradually adjust it while monitoring the charger's behavior (e.g., charging current, voltage).
Observe how the charger responds to changes in the potentiometer setting.
Fine-tune it based on your specific battery type and desired charging characteristics.
Remember that precise adjustments depend on the charger's design and the battery you're charging.
4/9/2024 5:47:52 AM •
Motorcycles
•
24 views • 2 helpful votes
What is the length of lift cables on a 1993 model 2693 hilo camper and any info on what after market part to use ? thanks
The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.
4/11/2024 2:06:02 PM •
Motorcycles
•
18 views • 1 helpful votes
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 5:36:50 PM •
Motorcycles
•
31 views • 0 helpful votes
Not finding what you are looking for?