20 Most Recent 2007 Bajaj Platina - Page 6 Questions & Answers

did problem happen when you attempted to pull off? if so it could be do do with the safety cut out sensors, i.e the stand the sensor might think the stand is down when it is actually up so the bike will cut out for safety reasons,

bike clutch plates are normally running in special oil as they are wet clutches for them to burn they will be running dry read the workshop manual and if you don't have one go google and type in workshop manual for bajaj motor bike boxer model- look for a pdf version to down load

Electronic Circuit Projects Visit this site for more details. http://electrohelponline.blogspot.com/

we dont know sorry

Hi, it could be the rod movement is not set properly if its going to far it could be opening the oil seal allowing oil to by-pass .

Hello, where are you accessories problems? If you buy a motorcycle, need in motorcycle accessories, you can refer to the below website.http://www.motorpartstore.com.Good luck and have a nice day.

the indications are that the battery is not good and will not supply enough current when the starter is operating to work the electronics Start with the battery and have a load test done it is the same indications for a car where it will not start off the starter but will from a push start

Hi Gambhir: It is unlikely that you will receive this information from a FIXYA helper. That is because the information would assist dis-honest persons in being able to steal motorcycles.

How To Motorcycle Repair