20 Most Recent
2008 Genuine Scooter Roughhouse R50 - Page 8 Questions & Answers
Where is vtx 1800 starter located
The starter on a Honda VTX 1800 motorcycle is located on the right side of the engine, beneath the chrome engine cover. You will need to remove the cover to access the starter motor. The starter motor is a small cylindrical unit with wires running to it. It is responsible for turning the engine over when you press the starter button. If you are having trouble starting your VTX 1800, it is possible that there is an issue with the starter motor, but there could be other causes as well, such as a dead battery or a faulty ignition switch.
3/13/2023 10:23:07 PM •
Motorcycles
•
Answered
on Mar 13, 2023
1994 VT1100 Front cylinder exhast sounds like a Jetsons car
Check all the points where there is air/exhaust going in and out of the cylinder. Sometimes the pop noise is a loose fitting or a hole in one of the flexible pipes.
Another possible cause is your fuel/air mixture isn't correct. Does the noise change with added Choke? Is the Exhaust smoke thicker and a dark grey/black colour?
Is yours the Twin Carb setup? The carbs might be out of balance and one is running richer than the other.
When the engine is cold, you could remove and inspect the spark plugs to see if they look the same colour. You're looking for either black, sooty plugs (rich mixture), or a clean, Pale white colour (lean mixture). A good plug will be more of a brown colour.
3/7/2023 7:42:14 PM •
Motorcycles
•
Answered
on Mar 07, 2023
Only one section of my jets is operating. All other jets aren't putting out any air???
If only one section of your jets is operating and the others are not, there could be several potential causes:
- Clogged jets: If the non-functioning jets are clogged with debris or mineral buildup, they may not be able to produce bubbles. You can try cleaning the jets with a jet cleaner or a solution of water and white vinegar.
- Airlock: Airlock can occur when there is air trapped in the plumbing system. This can prevent water and air from flowing to the non-functioning jets. You can try running the pump on high for several minutes to see if this will dislodge any air bubbles in the plumbing.
- Pump problems: If the pump is not working properly, it may not be able to provide enough water flow to the non-functioning jets. Check the pump to ensure that it is working properly and producing sufficient pressure.
- Damaged or worn out jets: If the jets are damaged or worn out, they may need to be replaced. Check the jets to see if they are cracked or broken and replace them as necessary.
If you are unable to diagnose and repair the issue yourself, it may be best to contact a professional pool or hot tub technician who can help you identify the root cause of the problem and provide a solution
3/5/2023 4:32:07 PM •
Motorcycles
•
Answered
on Mar 05, 2023
Not finding what you are looking for?