Top 20
2007 Aprilia SR 50 R Factory Questions & Answers
Scooter manuals
Turn the key on, hold the clutch in and push the start button!
I have new sr50. Since frist ride strange noise in
Hello and welcome to FixYa!
There can be a hole in the exhaust system. If there's a hole in the exhaust pipe a noise can be expected. You may need to have it spot welded to resolve the issue.
It can be an exhaust gasket or a loosen bolt on the exhaust as well so you may start on that first.
Hope this helps and thank you for using FixYa! Have a good one!
I HAVE JUST BOUGHT THE
when you lift the seat to fill the gas tank there is another knob there next to the gas on thats where there oil goes
hope this helps
John
Hello, yesterday some one came
Great question - I would grab frame numbers vin numbers and engine numbers and any other info to identify the bike and start calling the manufacturers pretty hard to crack codes of 5 numbers
They at least may point you to someone that can assist? good luck !
I have a 2007 keeway f-act 50. it has developed a
I will recomend you to clean the carburetor and change the spark plug. If the spark plug is bad it might get problems to set fire to the gas. so change it and you might get your motorcycle working again. Good Luck.
Will not start Aprilia Mojito Custom
OK< can you provide more details? Does it turn over? Does it fire at all? Do you know if you have a spark? Do you know if fuel is getting through? Has it run properly recently?
To run, a motor needs fuel, air and spark
Inspect all fuel lines and wires. Pull the sparkplug and see if it is burnt/wet/corroded
11/20/2019 10:36:25 PM •
Aprilia...
•
262 views • 0 helpful votes
I have installed a new ignition on y aprillia pegaso 2008 and it wont accept the code numbers
It's not the new switch, it's the new keys that have to be programmed.
The keys have uniquely coded chips in them, when you turn on the ECU uses the antenna that is by the ignition switch to look for a code that it recognises, you need to introduce the new key codes to the ECU.
This is what the manual says:
In case of installation of a new ignition switch the procedure is as follows:
Turn ON using new key
The dashboard will not recognise the key and will ask for the customer code: insert the customer code. It is 00000 when supplied. It can be changed to any numeric five digit number.
Now you can enter: MENU, DIAGNOSIS (insert the service code 25973),
Then select MODIFY KEYS and implement the procedure.
If you are not sure about the mode switch, this is what you do:
Use handlebar "mode" switch (left / right) to select "Menu" option on the screen, then press mode switch in to enter.
Use handlebar "mode" switch to select "Diagnosis", press to enter.
Use handlebar "mode" switch to enter the workshop code (25973).
When you have selected the digit you want then press in and it will move to the next digit etc.
You can't screw anything up, if you do it wrong go back or turn off and start again.
2/24/2019 8:21:45 PM •
Aprilia...
•
384 views • 0 helpful votes
Do you put water in a Aprilia Leonardo 125 2009
The coolant system on any engine, including bikes and scooters, does not use just water. You will need a coolant mixture which you dilute with water. There are several types of coolant mix so it would be a good idea to ask an Aprilia specialist exactly which type of coolant mix to use.
9/27/2018 3:12:37 PM •
Aprilia...
•
89 views • 2 helpful votes
Not finding what you are looking for?