20 Most Recent
2007 Honda Shadow VLX Questions & Answers
What tools do i neeed to change stator
Torque wrench capable of 12 N-m or 9 lbf-ft
Torque wrench capable of 103 N-m or 76 lbf-ft
Specified Honda Flywheel Puller or a Flywheel Puller with small arms
Specified Honda Flywheel Holder or a strap wrench
Gasket scraper
Gasket sealant
Electric start wont work
Have you tested battery voltage? ideally looking for 12.5v min.
If voltage is ok next thing to check is the cranking voltage drop, if it's very low battery problem!
Why is there fuel comming
Sounds like the petcock needs to be rebuilt. You should replace the fuel line and vacuum line also. Kits are about $20 depending on the year of your bike
Can i jump start my 96 honda shadow with my car?
yes but if bikes batt is bad it wont run rite once car cables are disconnected cause spark always comes from battery-not the alternator like a car--shadow may have a bad starter relay-thats coomon issue with old bikes-its shown in a repair book
Honda Shadow VLX600 Problem\r\nDo I need to clean
Yes all fluids should be changed,dont forget the brake fluid.The brake system may need carefully checking before riding since unseen corrosion could damage things over that time.
You should have a tire shop check the tires as they could become perished and unsafe over that period of time.
Honda 500 TRX fa6 has PS on the dash….what does it mean ?
The Power Steering has failed. There has been a factory recall for a suddenly failing electrical steering shaft, that could cause the rider to loose control. This does not have to be your problem but anyhow either the electronics or the pump failed. Error codes or messages usually have to be erased by a simple reset procedure or disconnecting a plug, after repairs are done.
3/26/2024 9:47:07 AM •
Honda...
•
Answered
2 days ago
Hiss works but
On the bottom of your speedometer on the left side there is 2 buttons
press the far left one for a couple of seconds and the light should go on
1/8/2024 6:42:24 AM •
Honda...
•
Answered
on Jan 08, 2024
What to torque the head on my 99 CBR 929 Honda in
For a 1999 Honda CBR929RR, the cylinder head bolt torque specifications are essential to ensure proper engine assembly and function. When tightening the cylinder head bolts, it's crucial to follow the manufacturer's recommended torque settings to prevent damage to the engine components.
For the CBR929RR, the cylinder head bolt torque specifications are typically as follows:
1. **Initial Torque:** 29 Nm (2.9 kgf-m, 22 ft-lbs)
2. **Final Torque:** 64 Nm (6.4 kgf-m, 47 ft-lbs)
It's essential to tighten the cylinder head bolts in the specified sequence and in multiple stages, gradually increasing the torque until reaching the final specified torque. The exact tightening sequence can usually be found in the service manual specific to your motorcycle model.
When torquing the head bolts, ensure you're using a reliable torque wrench calibrated in the appropriate units (Nm or ft-lbs). Always follow the tightening sequence precisely to ensure even pressure distribution across the cylinder head gasket.
Additionally, it's advisable to use new cylinder head bolts if the old ones have been previously tightened or stretched beyond their yield point. This helps maintain proper clamping force and ensures the integrity of the engine assembly.
As always, referring to the service manual or consulting a professional mechanic experienced with motorcycle engine assembly can provide additional guidance and ensure the correct torque settings are applied during the cylinder head installation process.
12/10/2023 4:27:33 AM •
Honda...
•
Answered
on Dec 10, 2023
2006 Honda Shadow Arrow 750 VT missing on the rear cylinder fire
. One possibility is that the spark plug or plug wire is faulty 1. Another possibility is that the carburetor needs cleaning and adjustment It could also be due to a valve adjustment issue or a bent rod.
I would recommend taking your motorcycle to a professional mechanic who can diagnose and fix the issue. If you prefer to troubleshoot it yourself, you can start by checking the spark plug and plug wire for any damage or wear and cleaning the carburetor. However, please note that working on a motorcycle engine can be dangerous and requires specialized knowledge and tools. Please take all necessary safety precautions and follow the manufacturer's instructions when working on your motorcycle.
10/22/2023 2:01:22 PM •
Honda...
•
Answered
on Oct 22, 2023
2007 honda shadow vt750 dies sputters on acceleration
The problem might be with the air filter, and if not there are a few other things that could be causing your Shadow engine to bog down on acceleration. This includes a dirty carburetor, carb adjustment issues, or other internal problems like damaged vacuum lines or a cracked manifold
8/31/2023 7:57:51 AM •
Honda...
•
Answered
on Aug 31, 2023
Just brought a Honda C102 Step Through. Does anybody know if its positive earth or negative earth. I just brought battery for it.
Question edited for clarity.
Question moved from Honda Cars.
I haven't seen one of those for 40 years!
The Braided cable goes to battery negative -
They normally have a Red Cable to the battery Positive +
And if I recall, there is an inline fuse in the positive?
Here is the cable
https://www.ebay.com/itm/NOS-OEM-Honda-Cub-50-70-C70-K1-C50-C65-M-CA102-C102-Cable-Earth-Battery-Ground-/172214475304?_ul=IN
and here
https://www.ebay.com/itm/225016392400
Service manuals x two :>D
Honda C102 Service manual
Honda 4-stroke.net
https://4-stroke.net > honda-c102 > downloads > 440-...
You can go to our downloads and grab yourself a copy! Download the Honda C102 Service Manual in the following format: pdf Service manual for Honda C102 (1.93 MB).
Service Repair Manual Honda C100, C102, C50,C70, C90
Blogger
http://myhondac100.blogspot.com > 2013/10 > servic...
Oct 21, 2013 - Service Repair Manual Honda C100, C102, C50,C70, C90.
http://www.servicerepairmanualonline.com/4449/honda-super-cub-50-c50- ...
7/22/2023 4:05:21 PM •
Honda...
•
Answered
on Jul 22, 2023
Not finding what you are looking for?