20 Most Recent 2005 Cpi GTR 50 Questions & Answers

i have a cpi gtr and everything is fine with it it start first time with kick start but wont start electrically and its a new battery what should i do?

The Internet, though, has a large number of web sites where you can buy service manuals and schematics from bookstores, publishers, and other collectors. Here is just a sampling of what sites are out there: Clymer Motorcycle ATV Marine Snowmobile Tractor Shop Service Repair Manuals Haynes is the information resource for the DIY enthusiast How To Motorcycle Repair

I have the same problem with mine a 2008. What do you find to fix your problem?

TIGHTENING TORQUES DESCRIPTION (MM) TORQUE (NM) FRONT AXLE NUT 12 60 REAL AXLE NUT 16 120 FRONT FORK BRIDGE CLAMPING SCREWS 8 20 BRAKE CALIPER BOLTS 8 25 HANDLEBAR MOUNTING BOLTS 34 -- SUSPENSION STRUT LOWER FASTENING BOLT 6 12 ENGINE HANGER BOLTS 8 20 TRANSMISSION HOUSING FASTENING SCREWS -- -- ENGINE CASE 6 12 CYLINDER HEAD 7 14-16 Flywheel 12 45 Clutch drum --- --- Clutch --- --- Transmission oil draining plug 8 10 Kick starter 6 12 Manifold 6 12 Muffler 6 / 8 12 / 20 Bolts / nuts without defined stipulations 6 12 8 20 10 40 12 60 Spark plug 14 15

Contact the manufacturer/distributor directly to inquire.

Spark plug is fitted into the cylinder head - somewhere! Cylinder head is at the top of the engine that has a vertical or nearly-vertical cylinder or with a horizontal cylinder is usually the forward-most part. Spark plug has a thick wire connected to it so if you can see a thick wire try following it... If you are thinking of replacing your bike's spark plug, take great care when refitting. The threads are fine and cross-threading is easy to do so always fit the new plug and screw in at least two full turns by hand and take great care not to overtighten it. Most new spark plugs are fitted with a collapsible washer to ensure a gas-tight seal. The washer can be felt collapsing in the last approximately 60 - 90 degrees of turning and equally it can be easily felt when it has finished collapsing. From that point it needs only a few pounds of additional pressure on a 6 inch wrench to finish the job. When refitting a plug with a used washer, once contact with the cylinder head is made, it only needs that small amount of wrench pressure for it to be tight enough.

https://www.youtube.com/watch?v=7hT4ex539N4 https://www.youtube.com/watch?v=wxPrBO9qRVg https://www.youtube.com/watch?v=QaVFvSbg1_I https://www.youtube.com/watch?v=yef7sgfcMwg&t=129s https://www.youtube.com/watch?v=7GdOMiwfhYg https://www.youtube.com/watch?v=v3G4tx3zcCY This last video show where the vent line or gas cap is not allowing the tank to vent . He just removed the gas cap and seemed to solve the problem.

look for any serial numbers it might have then put info into google. or come back on here with all the info and some one might be able to help you out.