20 Most Recent 2007 Kymco Venox 250 - Page 8 Questions & Answers

dead center in front of the forks, mine is above the horn

The accessories are available at this site http://kyps.kymco.com/kyglobal/accessories/access_product_list.html?mcatID=2752 click on 50 to 150cc scooters and select compagno 110i.

i have a 09volvo s40 i replaced the motor and no it want turk over by turning key its no geting any signal to starter and not geting any fuel perssuer

check your switch. contacts could be not making contact. or your flasher unit is bad.

check compression then check petcock (where gas comes from tank) both will cuz that

which model is it ?

you will need a puller

should be stamped on the headstock

I use Honda HP-2 mixed 32-1 but you can use most name brand 2 stroke oils

put some penertrating oil in lock and let it soak as you get weather in it , then work it carefully and it should free ! if not get a locksmith to open it then replace lock ! P...

Typically, Cooling fans only run when necessary. Are you sure you have a oil cooler with a fan on your Kymco?

Check if the speedo cable still turns when disconnected from the speedo end only.

The main ground comes from your main power source(the battery). The negative terminal post is where your ground attaches from the main wire harness. There are many other ground wired that come from the wiring harness. You will know which they are because they will be screwed against the frame. Good luck!

Hi David, seems you have a problem with the charging system on you steed. Regards John

Buy a manual. It will save you money in the long run. When you say "From Scratch" do you mean a complete engine rebuild as well? If so you would be better buying a different bike and doing a rebuild in slow time. The only reason I say this is that, if you have you ask for advice in a forum before you have started, then you don't have the skills to do the job quickly.

i would assume it waould be in your fuel line which goes from your gas tank shutoff valve to your carb

Check your sidestand switch, and then the ignition switch.

The best thing to do is to visit your local Kymco dealer with proof of ownership and the vehicle identification number and have them get you another key. Hot wiring the ignition could be a unsafe thing to do and it could damage other electrical components.

http://www.qrbiz.com/product/629641/chainsaw-connecting-rod.html

fuel not getting to carbKinked hose or blockage stuck float valveRide Safe Bike-Doc