20 Most Recent
2006 Kymco Xciting 250 - Page 2 Questions & Answers
How to remove the front panel of a Kymco 150 scooter?
To remove the front panel of a Kymco 150 scooter, you will need to follow these steps:
- Locate the fasteners that hold the front panel in place. These are typically located on the underside of the panel, along the edges.
- Use a screwdriver or other suitable tool to loosen and remove the fasteners.
- Carefully lift the front panel off of the scooter.
- If the front panel is attached to the handlebars or other parts of the scooter, you may need to carefully disconnect these connections before removing the panel.
It's important to be careful when removing the front panel to avoid damaging the panel or the scooter. If you are unsure of how to remove the panel or if you encounter any difficulties, it may be best to consult a mechanic or the scooter's user manual for further guidance.
12/31/2022 5:42:32 PM •
Kymco...
•
Answered
on Dec 31, 2022
Where is the freewheel lever on my kymco agility
It is positioned at the back of the mobility scooter. Low down on the actual motor there is a small red lever at the height of the wheel hubs. Usually just to the right of the centre, at about ankle height as you stand behind the scooter.
12/24/2022 10:32:41 AM •
Kymco...
•
Answered
on Dec 24, 2022
What should the compression be for a 2000 kymco super 9 liquid cooled
a SCOOTER. year 2000. not cc (LOL)
cloned version of Honda's AF18E/AF16E Dio motor.
Air cooled, 49cc, single cylinder, 2-stroke
Compression Ratio: 7.2:1
it's in the manual. RTM" service manual
there is computer model to calc, this using compression ratio and cylinder volume
but
here is generic list.
my lawn mower is 100psi;. (and mopeds and outboard tiny motors and scooters tiny not 250cc hog scooters)
my old car is 150psi
my newer car with high 10:1 CR , is 200psi
a 49cc engine 7.2 CR is like 80psi.
low and expected. at that CR, 100 max
to get the reading correctly
good guage
fast cranked (kicked or starter turned)
let the meter peak and peak is spec. read peak PSI
and the CR is what matters.
and only on a warm engine, warm/hot not cold
cold is way less.
when warm the rings seat, cold they do not.(well)
7/4/2022 1:51:27 PM •
Kymco...
•
Answered
on Jul 04, 2022
Not finding what you are looking for?