2006 Kymco People S 200 - Answered Questions & Fixed issues

In what state?

check your fuses as well as connections to your coil check your on off switch for power. use a test light for these tests it has to be electrical source related

The carburetor is gummed up a bit from petrol evaporating over the past year. Remove the carb and then the float bowl on the bottom of the carb and then clean the carb with spray carb cleaner. Pay extra attention to the float needle area. A generic diagram is below. Please rate my answer. Thanks.

The battery may be drained. This is both true for kick start and those with a starter motor. See if you can jump start the bike when you push it and put it in gear. If it starts it is a battery issue.

You can buy a thread tap at most any good auto parts store or hardware / tool store. The tap will re-thread the existing threads. Bear in mind that if the hole has been stripped out really bad, the integrity of the re-thread is questionable. Having a local machine shop do the re-tap is advised. Alternate to that is just buying a new cylinder head. Please rate my answer. Thanks!

Wneh you fit new rings be sure to scour the cylinder bore with a rotary wire brush in the chuck of an electric drill, otherwise the rings won't seat correctly and it may burn oil and lose compression.
Treat as a new engine and run the rings in.

It should be the negative side of the battery or the frame.
Hope that helps

When you kick start a motorcycle or scooter, the motor turns over much faster than your electric starter can turn it over, even with a new battery.
I saw this before with several brands of scooters and the problem was solved by making sure you have clean battery terminals, and a fully charged good battery.
Some batteries will take a full charge but cant take a load. So your battery may seem good because it has 12+ volts, but when you try to start it it drops below 10-11 volts.
Most local auto parts stores can put a load test on your battery for free. If you purchase a new one, make sure it is the one called for for your scooter.

There are only three things that could do this:
1. Air intake restriction
2. Fuel restriction.
3. Throttle cable slippage.

Please check the filters, the throttle cables etc.

Here is a link to the service manual

If you pull the seat bucket you will be able to trace your fuel and vacume line to the petcock. You can help the process by manualy applying suction at the vac line and a shot of starting fluid in the airbox inlet should get you going.

At 300 miles the only thing you might want to do is check the gearbox oil level and then lube and adjust the chain. Check with the dealer on the filter type. As to what type of oil, use 10w40 motor oil in the gear box. Don't use any synthetic oils, oil marked "EC", or oil with "special" additives. Stick with the major brands; Pennzoil, Quaker State, Mobil or Shell. If in a hot area like Texas or New Mexico go with 20w50.

Please rate my answer. Thanks!

I would separate the feed wires from the fuse box/ distribution point and measure any current draw in the separate feeds. That will tell me instantly where the fault/leak is.

Normally white smoke is water in the combustion chamber but this is air cooled so either too much fuel, incorrect fuel or burning oil can cause this.

Question edited for clarity and toss in some CAPS. Question moved from Garden category. Fuel delivery issue. See if there is any in the fuel tank. Stuck float in the carb. Blocked jets in the carb. https://www.google.com/search?q=kymco+k+pipe+125cc ..

Question edited for clarity, typos and spelling. Engines only need 3 things to run Fuel, which must be clean and not 2 years old. Compression. A Spark at the right time. One of the above is not there on your ATV. Flywheels don't break. Check the spark plug is clean and correctly gapped. Service Manual

Troubleshooting - KYMCO MXU 450i Service Manual

ManualsLib https://www.manualslib.com > ... > Service manual KYMCO MXU 450i Manual Online: Troubleshooting. Engine won't start • Battery voltage too low • Fuel level too low • Pinched or clogged fuel hose • Faulty ... More here https://www.google.com/search?q=kymco+uxv+450i+won%27t+start ..

Check the fuses on it. Lights are on a fuse. Google make model manual

Using a volt meter, check to see if there is voltage at the wire connector at the light. If there is enough voltage, then you have a bad light or bad ground. If no power, then look at the switch or a bad wire/connection .

Are you using the remote? Replace the battery in it. Will it fold using the buttons on the unit? Additional 'child safe' buttons for folding & unfolding are located just under the drive controls, just in case you should misplace or lose your personal wireless remote. https://www.google.com/search?q=kymco+k-lite+fe+not+folding ..

agility city 125 Workshop-manual : Page 3 - bike-parts-kymco.uk

bike-parts-kymco.uk https://www.bike-parts-kymco.uk > catalog > page3 Order your original Kymco ATV, Scooter & Motorcycle spares with our part diagrams ?? Search by model or part number ?? Manufacturer warranty - Secure ...

Tires sizes for KYMCO Agility 125 2017

MotoTireFinder.com https://www.mototirefinder.com > ... > Agility 125 What are the tires pressure for KYMCO Agility 125 2017? · 25 PSI (~1.72 BAR) · 32 PSI (~2.21 BAR). Front Tire Pressure: 25 PSI Front Tire Dimensions: 120/70-12 Rear Tire Pressure: 32 PSI Rear Tire Dimensions: 130/70-12