Kymco Stryker 125 - Answered Questions & Fixed Issues

Hi, Ian for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kymco, despair not, for a mere $15 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Kymco Stryker 125 150 Service Repair Manual Download Download Manuals... $15
KYMCO Stryker 125 User Manual

Kymco Stryker... | Answered on May 04, 2019 | 139 views

check with a dealer mechanic but generally the scooter is small capacity and depending on your body mass , 35-40 mph is approaching the speed limit of the scooter

2005 Kymco... | Answered on Oct 24, 2017 | 79 views

You probably need a new clutch. That can explain why it bogs. The smoke I don't know.

Kymco Stryker... | Answered on May 31, 2016 | 125 views

fit in a helical, and keep in the same bolt, that should solve your problem

2005 Kymco... | Answered on Aug 29, 2015 | 365 views

did you replace the whole indictator assemblies or the bulbs and are they l.e.d indicators you have on it now and was it using l.e.d ones originally

Kymco Stryker... | Answered on Jan 16, 2015 | 84 views

Line up the magneto timing mark for top dead center with the mark on the engine case then line up the timing mark on the cam gear with the mark on the head. Once those two marks are lined up then the timing is set.

2004 Kymco... | Answered on Jan 05, 2015 | 4,093 views

There is one fuse and it is where the battery bracket is holding the battery in

2001 Kymco... | Answered on Aug 12, 2014 | 73 views

There are a couple of reasons the starter would just click when trying to start. The battery could be low or one of the connections could be corroded and not allowing full current to the starter motor.

2004 Kymco... | Answered on Jul 17, 2014 | 111 views

Typically the flywheel is keyed to the crankshaft and cannot move without rotating the engine also. If the key is sheared then the flywheel can move without moving the crankshaft. To check this the flywheel needs to be removed and replace the key. Of course the reason for shearing of the key needs to be corrected before the problem is fixed.

2004 Kymco... | Answered on Jul 17, 2014 | 92 views

Bad ground. Find the fault and fix it.

Kymco Stryker... | Answered on Oct 24, 2013 | 13 views

fuel filter or carb?

2005 Kymco... | Answered on Jul 05, 2013 | 665 views

try take of ur exhaust at the engine, their like a washer just remove it, if that works check ur insurence u might not b covered?

2005 Kymco... | Answered on Jun 23, 2013 | 171 views

its not likley to be the battery its the charging systen on the bike thats faled on you check the regulator is working then all the fuses are good ones

2005 Kymco... | Answered on Jun 11, 2013 | 671 views

try some WD-40 not a lot just a squirt inside let it sit for awhile and then slowly with some pressure try to get it worked in..try a little more lube if that doesnt work your gonna need to take it off and take it to a locksmith they might be able to repair it!

2005 Kymco... | Answered on May 06, 2013 | 597 views

How do I derestrict a kymco stryker 125

2005 Kymco... | Answered on Oct 08, 2012 | 461 views

Line up the holes so that the big hole is in the middle and two smaller ones are on top and bottom.. Adjust valves from there

2005 Kymco... | Answered on Jun 29, 2012 | 254 views

Somewhere on the bottom or bottom outside edge of the gearbox is a drain plug. Drain the oil and put the plug back in place. Somewhere on the top of the gearbox casing, including the left and right outer case covers, you will find a dipstick for checking the oil level. Fill via the dipstick hole. Some bikes don't have an actual dipstick but only have a top plug. Normally you will find it near the kick starter lever. When no dipstick is provided, they expect you to drain the old oil and then re-fill with the amount of oil specified for the bike. Use 10w40 motor oil. NEVER use synthetic oils. They can screw up the clutch.

2005 Kymco... | Answered on Apr 14, 2012 | 494 views

there are different methods of restricting, hear we 1. gasket between the carb and inlet. ". gasket between the exhaust and head, 3. washer in the output sprocket to drive to wheal in the centrifugal clutch Re: Jeff

2001 Kymco... | Answered on Apr 12, 2012 | 410 views

check the switch on the stand may not be opening. normally if you leave the stand down it will cut the engine when you put it in gear, its a safety switch.

2001 Kymco... | Answered on Nov 01, 2011 | 176 views

Not finding what you are looking for?
Motorcycles Logo

-43 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Kymco Experts


Level 3 Expert

84625 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5860 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides