Kymco People S 200 - Recent Questions, Troubleshooting & Support


carb,air filter?if it is only downhill maybe the chain can't keep up since you are at max.auto clutch?that's something different.good luck.

2005 Kymco... | Answered on May 11, 2018


Hi, Shirley and the usual suspects are:
1. The front wheel or transmission drive unit has failed.
2. The drive unit tab is not properly indexed.
3. Broken speedometer cable.
4. The speedometer has failed.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Speedometer not working
Trouble shooting speedo cable
http://www.49ccscoot.com/manuals/Kymco_People_S_50-200_Service_Manual.pdf
Kymco Scooter Parts
KYMCO People 250 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2009 Kymco... | Answered on Apr 29, 2018


Hi, Barbara for more information about your question and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Gasket Set Full for 2004 Kymco People 150 eBay
Top End Gaskets Kit Top End Gaskets Kit Athena Aftermarket Division
KYMCO GRAND INK 125 Service Manual
Kymco Scooter Parts ATVs Scooter Parts Performance Scooter Parts...
KYMCO PEOPLE 50 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2005 Kymco... | Answered on Aug 30, 2017


Hi, Dave the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Accelerator pump damaged or not working.
11. Water or dirt in the fuel system, carburetor or filter.
12. Restricted, blocked or kinked fuel line.
13. Fuel tank empty.
14. The gas cap is not venting properly or fuel tank venting system blocked.
15. A failed fuel pump, pressure regulator and or fuel injectors.
16. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
17. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
s200 stalls after 5 10 minutes
GY6 stalls immediately after starting
problems with my Kymco 200 People
http://www.49ccscoot.com/manuals/Kymco_People_S_50-200_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2010 Kymco... | Answered on Jun 15, 2016


Hi, Adma despair not all is well too much oil only clogs the breathing system of the engine and causes the tempory sluggish loss of power, always check your engine oil level with the engine at operating tempurature for more information about your question and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
Help overfilled engine oil motorcycles
https://forum.motorcyclenews.com/topic/57129/the-dangers-of-too-much-oil
http://www.fireblades.org/forums/honda-fireblade/103871-worried-have-overfilled-oil.html
http://www.49ccscoot.com/manuals/Kymco_People_S_50-200_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2005 Kymco... | Answered on Mar 13, 2016


Hi Hankcycle, for more information about your question please visit the website below. Good luck and have a nice day.
https://absolutelyscooters.net/manuals/Kymco_People_S_50_125_200_Service_Manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2005 Kymco... | Answered on Oct 03, 2015


That depends on the number of participants in 2005.
If you don't give the full problem then we can't give you an answer.

2005 Kymco... | Answered on Sep 11, 2014


Under the seat you should find a fuse box with the ignition fuse blown............Hope this helps.

2005 Kymco... | Answered on Jul 28, 2014


THE REASON FOR A HANDLE BAR LOCKING MECHANISM IS TO PREVENT SOME ONE STEELING THE MOTOR CYCLE ALL I CAN SUGGEST IS GET IT DONE AT A MOTOR CYCLE SHOP.

2005 Kymco... | Answered on Oct 19, 2013


check your fuses as well as connections to your coil check your on off switch for power. use a test light for these tests it has to be electrical source related

Kymco People S... | Answered on Sep 04, 2012


u need to read your owners manual, it help me, it can help u to,take the time.

2005 Kymco... | Answered on Aug 29, 2012


battery is low and needs charging most likely.

2005 Kymco... | Answered on May 12, 2012

Not finding what you are looking for?
Motorcycles Logo

-20 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Kymco Experts

Marvin
Marvin

Level 3 Expert

84581 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5823 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kymco Motorcycles

  • Forum

View Most Popular

  • Kymco Motorcycles
Loading...