Kymco Hipster 125 - Recent Questions, Troubleshooting & Support


potrzeb?je insterukcie obs?ugi do kymco hipster 125

2003 Kymco... | Answered on Mar 18, 2018


Hi, John you may want to try using some penetrating oil or an "Easy Out" or just drill it out, for more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
What is the best way to remove stuck rusted exhaust bolt
Removing Tough Exhaust Bolts
KYMCO Hipster 125 Service Repair Manual Download Download Manuals Technical $15
Part Diagrams
KYMCO ZING 125 Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2003 Kymco... | Answered on Mar 05, 2018


Hi, Anonymous before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter motor or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. Faulty ignition relay.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Bike won start any ideas
What Do Check When My Motorcycle Won Start Honda Shadow Forums Shadow...
Kymco Hipster 125 150 Motorcycle Complete Workshop Service Repair Manual... $20
Genuine Kymco spare parts
Manuals Kymco

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2002 Kymco... | Answered on Sep 11, 2017


strange but true I had a similar thing after going into my front area, what I had done is put the correctly wired wrong bulb in the indicator and vice versa into the side headlight, not an easy thing to do considering the two are physically separated but that's me, so then my side light was acting as indicator and my indicator was on constantly, in some way could you have done the same thing?

2003 Kymco... | Answered on Jul 20, 2017


Hello Anon,
You simply need to take it to a qualified professional and have them clean and set the carburetor,,, it will be fine after that,,,
good luck,,

2003 Kymco... | Answered on Jun 30, 2017


Battery Fuse : 20A Reserve Fuse :15A Headlight Fuse : 15A Radiator Fan Fuse : 10A All Electric Power Fuse :15A

15 amp

2004 Kymco... | Answered on Apr 10, 2015


the valve timing mark is on the flywheel on the Hipster's.

Remove the large flat blade screw from the top of the left hand side casing. Turn the engine either by hand (using kickstart with ignition off), turning rear wheel in gear, or by removing the "kymco" badge with three 8mm bolts and using a 19mm deep socket on the crank, until you see two marks (one says F one say T) the F one is the advance firing mark, the T mark is the timing mark. Keep turning the engine over and watch your valves, wait for the exhaust valve to close, inlet valve to open and then close again then the next time you see the T line will be TDC. This is where you set your valve timing from.

2002 Kymco... | Answered on Aug 18, 2013


Check your rectifier. Do a hydro test on your battery if you can get into it. Should be 1200 or more. If the battery is 3 years old or more - replace it.

2004 Kymco... | Answered on Jun 19, 2013

Not finding what you are looking for?
Motorcycles Logo

-22 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Kymco Experts

Marvin
Marvin

Level 3 Expert

84524 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5821 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kymco Motorcycles

  • Forum

View Most Popular

  • Kymco Motorcycles
Loading...