kawasaki ZX-7R - Answered Questions & Fixed Issues
Overcharging
There should be a voltage regulator which has the job of keeping the voltage at the right range. Look for a finned box near the computer.
Hit starter button fuel pump clicks and nothing happens 2000 zx7r
Most likely bad fuel pump, but double check connections to the fuel pump and ground Bright and shiny connection surfaces are the best. Starter turn? the click is probably not the fuel pump, It is probably the starter solenoid. Double check all connections including battery. Check battery condition and charge. Sounds like low battery with just enough "juice" to make the solinoid click and not much more. Owner's manual? Troubleshooting section?
My 1996 zx7r keeps poping the ignition fuse
when you install a new fuse or only when you turn the key on ??? more info would help here. but if its just when you install the fuse suspect your problem is before the switch. if when you turn the key on, I'd start looking at getting a wiring diagram
My zx7r wont crank after falling over
First thing I would check is the run/stop switch. Second make sure it goes in neutral. Third make sure clutch is working before going to a shop, just a few simple thing to check if you haven't already good luck.
1999 zx7r diagrams
This is fairly easy, connect your fuel line to the on off res control aim the bleeder line from back of tank down toured the ground not aimed at engine replaced the two bolts I front and replace two bolts under seat and seat clip if part of that asse
Wont fire up after its been running a whlie
May have a vapor lock in the fuel line. Rerouting the line may help. If you are in a jam, try putting ice on the fuel lines, I know, it's gonna be tough but it will solve a vapor lock.
No electrical after sudden braking on highway
Probably a broken cable where the insulation has not been broken by the shock load, have a look at the ground terminal area it can look ok but a pull on it to feel any stretch will do it and if not try others in battery area, test main fuse they can look visually ok but may be fractured.
I have a zx7r ninja and yesterday it worked fine
Clutch plates may have worn out OR If hydrolic clutch then it may need re-bleeding or if cable- May need replacing or adjusting
Check them few things you will most likely find its the clutch plates need replacing.
My idle cable came lose how do i fix it
You will find the Idle cable screw hole in the middle of the carbs between two and three, It screws directly in between the two at the bottom, You can quite clearly see the screw hole, You have to first take off the petrol tank, then the Air filter housing, It is best to take off the carbs as well for easier access to the Idle worm drive screw hole though, There are only four screws holding the carbs on via four thin duabley type clips, You will need a long X-head or a Phillips for this, You will need an 7 or 8mm socket and a 10mm socket for the tank and an 8mm socket for the Air filter housing, I hope this helps, :)
Im having problem with my
Hi. I believe the selonoid on the starter maybe the problem. If you can bench test the motor to check if it runs. Replace the selonoid and see. Good luck.
2/17/2013 8:28:09 AM •
2003 kawasaki...
•
Answered
on Feb 17, 2013
•
1,070 views
Not finding what you are looking for?