Hyosung Motorcycles - Page 3 - Recent Questions, Troubleshooting & Support

Hi there should be a key to remove the seat my gt650r has one.

Are you sure that wire goes to the battery?

I would clean the jets again and blow out with compressed air its happened to me cleaned it and more dirt went straight back in from dirty tank give it a try nothing to lose

Hi every 1 my bike is leaking petrol out of this small hole when i accelerate what does this mean,?? T.i.a

Time for carb cleaning , blow the jets with compressed air,check the float level.
Check the spark plug and replace if neccessary.
Check the air filter too, and if you don't have an 'inline' filter for your fuel line,install one.
Basically yr bike's engine needs a tune up...check the valve clearance too!
Hope this helps!

yes only use the manufacturers recommended oil viscosity .

try looking at the timing

maybe the oil is boiling and turning into gas..

Do you get anything at the push button? Might be worth checking the condition of the battery, the starter solenoid, the main fuse and the starter itself as this sounds like an electrical issue. See if you can get the battery tested 'under load' as the cold can make old batteries sluggish.

what is question

Tune up.

http://suconsultaonline.com http://elpsicologoonline.com http://unmedicoonline.com http://unabogadoonline.com http://eldoctoronline.com http://unpsiquiatraonline.com http://midermatologoonline.com http://miginecologoonline.com http://miveterinarioonline.com http://elpediatraonline.com http://losabogadosonline.es http://abogadosespa?a.com http://xn--abogadosespaa-tkb.com http://consultspecialists.net http://consultaespecialistas.com http://uncirujanoplastico.com http://cirujanoplasticocesar.com

If the bike is a carburettor model you need to clean your jets. Sounds though you have blocked main jet. Im guessing bike has sat for a while at some stage.....

sounds like an air leak to me check your intake manifolds the rubber could be drying out and starting to crack hope this helps

Sounds a like a faulty indicator relay.

Using a pencil or permanent marker, mark the location of the switch assembly. Unscrew and remove the assembly. Use some cloth or plastic tape to build up the area under the screw assembly. Replace the assembly. The cloth/plastic tape will give the unit something to bite onto. You can also use thin rubber in place of the tape. Semper Fi, Z

Make sure your gas cap is venting. Maybe, next time it dies loosen the gas cap see if anything changes.

Should be pretty easy and you might have to take the rear tire off. Usually have to take off the caliper to get the brake pads out and new ones in.

You should be able to find a manual online that can help you set the timing.

Check your fuses