Gilera Motorcycles - Recent Questions, Troubleshooting & Support


Hi, Daniel and the usual suspects are:
1. Throttle cables improperly adjusted.
2. Idle screw set too low.
3. Faulty air control valve.
4. Faulty stepper motor.
5. Faulty WAX unit.
6. Faulty MAP sensor.
7. Faulty ECU.
8. Clogged charcoal canister.
9. Fuel pressure too low.
10. Leaking intake rubber hoses between the throttle valve housing and cylinder head.
11. Throttle valves not correctly synced.
12. Throttle position sensor (TPS) not correctly adjusted.
13. Valve clearances are too tight.
14. Low compression.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://forum.twistngo.co.uk/viewtopic.php?t=9430
How to Adjust Your Scooter Engine Idle Speed QuikrCars Do It Yourself...
https://www.manualslib.com/manual/1014411/Gilera-Runner-50-1997.html#product-Runner%20VX125%202004
https://www.oemmotorparts.com/oem2.asp?M=gilera
https://www.google.com/search?q=gilera+runner+vx+125+owners+manual+pdf&tbm=isch&source=univ&sa=X&ved=2ahUKEwijjfT3ssniAhWOtlkKHTc1DoMQsAR6BAgFEAE&biw=1440&bih=757

2006 Gilera... | Answered on Jun 01, 2019


Hi, Femi before testing any electrical component in the Starting Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Engine Run Switch is "FAULTY" or corroded.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand, clutch, neutral safety switch.
10. Security alarm needs a reset.
11. Starter relay, solenoid, starter motor or circuit wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. Faulty ignition relay.
15. The electric starter is working but starter clutch has failed.
16. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://forum.twistngo.co.uk/viewtopic.php?t=11043
What To Do If Your Motorcycle Doesn Start
http://www.bellamoto.rs/upl/files/RUNNER/Runner%20RST%20125%20-%20200%20TEHNICKO%20UPUTSTVO.pdf
https://www.oemmotorparts.com/oem4.asp?M=gilera&T=runner%20vx-vxr%20125-200%20%20125&Y=2003&L=GI_RNR125
http://www.freebooks.me/get-file.pdf?q=gilera_runner_vxr_200_manual_pdf

2006 Gilera... | Answered on May 29, 2019


First check your main fuse, then check the fuse in the starter relay.

2005 Gilera... | Answered on May 27, 2019


RH side of the bike, on the frame rail heading upwards behind the passenger footpeg

2011 Gilera... | Answered on May 27, 2019


Hi, Rado it sounds like you need the valve clearance checked. It sounds like it is a bit tight and needs to be adjusted.

2008 Gilera... | Answered on May 27, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Gilera, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.youtube.com/watch?v=af-4WL9bafc
https://www.outilsobdfacile.com/data-trouble-code-obd2.php
http://www.bellamoto.rs/upl/files/RUNNER/Runner%20RST%20125%20-%20200%20TEHNICKO%20UPUTSTVO.pdf
https://www.oemmotorparts.com/oem2.asp?M=gilera
http://www.bellamoto.rs/upl/files/Runner%20ST%20125%20-%20200%20UPUTSTVO.pdf

2010 Gilera... | Answered on May 15, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Gilera, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.manualslib.com/manual/689433/Gilera-Nexus-500.html?page=296
https://www.louis.eu/rund-ums-motorrad/bike-datenbank/gilera-nexus-500/nexus-500/1313
https://www.manualslib.com/manual/1343970/Gilera-Nexus-500.html
https://www.ajsutton.co.uk/spares/chooseModel.asp?make=gilera&uID=0
https://www.manualslib.com/manual/1560815/Gilera-Nexus-500.html

2007 Gilera... | Answered on May 14, 2019


Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Gilera, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Modern Vespa Dead Battery Can unlock seat
http://scootercommunity.com.au/forums/t/18224.aspx
https://www.manualslib.com/manual/689433/Gilera-Nexus-500.html#product-Nexus%20500
https://www.oemmotorparts.com/oem3.asp?M=gilera&T=NEXUS%20%20500
http://pr01.silverhost.cl/gilera_nexus_owners_manual.pdf

2007 Gilera... | Answered on Apr 20, 2019


Hi, Edward for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Suzuki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Wiring+diagram+Gilera+50+RCR&tbm=isch&source=univ&sa=X&ved=2ahUKEwjFmqjD8drhAhUNm1kKHVxJBfoQsAR6BAgJEAE&biw=1440&bih=757
https://www.sip-scootershop.com/scooterbase/Download.aspx?ID=8247f674-cfcd.
Gilera SMT RCR 633793 Service Station Manual
https://www.oemmotorparts.com/oem4.asp?M=gilera&T=rcr%20%2050&Y=2003&L=GI_RCR
http://www.bellamoto.rs/upl/files/RCR%2050%20UPUTSTVO.pdf

Gilera 50 RCR... | Answered on Apr 19, 2019


It sounds as though the mixture is way too rich. Is the choke stuck on or malfunctioning? With is dry spark plug but fuel in the carburetor, try turning the fuel valve and choke off and then with ignition on and holding the throttle at least 1/2 open, kick the engine over several times. If it starts under these conditions then perhaps the float(s) in the float bowel have leaked and are full of gasoline causing the fuel to flow continuously into the throat of the carb then into the engine. It probably is some sort of carb mixture setting, choke or needle valve/float problem.

Gilera... | Answered on Mar 19, 2019


Hi, Johnny for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Gilera RTX 125 wiring diagram Google Search
Gilera
Free Gilera Motorcycle Service Manuals for download
Motorcycle Parts for RTX for sale eBay
https://www.google.com/search?q=gilera+rtx+125+owners+manual&rlz=1C1CHBF_enUS792US792&tbm=isch&tbo=u&source=univ&sa=X&ved=2ahUKEwi1md-CjMndAhUJoFMKHfiDBtoQsAR6BAgGEAE&biw=1440&bih=758

Gilera... | Answered on Sep 20, 2018


Hola, Jose para este escenario, necesitar?s tu manual de servicio que tiene todas las especificaciones de torque de los sujetadores y un diagrama de cableado en las ?ltimas p?ginas, las fichas de piezas y el manual del propietario si no puedes encontrar la mejor herramienta que jam?s hayas comprado para tu Gilera. no, por un simple $15 puedes descargar otro. Para obtener m?s informaci?n acerca de su problema y las valiosas descargas "GRATUITAS" que necesitar? para ver o imprimir, haga clic en los enlaces azules a continuaci?n. Buena suerte y que tengas un d?a maravilloso. Resetting your service light on Piaggio MP3 scooter
RESET REMEN PIAGGIO
2007 2009 Gilera Fuoco 500 Workshop Service Repair Manual Download Manuals... $15
Gilera Fuoco 500 Parts Spares Only Genuine Parts Sold Guaranteed
Gilera Fuoco 500ie Manual

2007 Gilera... | Answered on Sep 05, 2018


Hi, Dtav the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Gilera GFR 125 power valve Google Search
Gfr Power Valve
Please Check First
Gilera GFR 125
http://www.motorcyclespecs.co.za/model/gilera/gilera_gpr_125sp.htm

Gilera... | Answered on Jul 28, 2018


Possible warped/cracked head or cylinder wall.

Gilera... | Answered on Jul 23, 2018


Hi, Billy the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
Good luck and have a wonderful day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Gilera... | Answered on Jun 25, 2018


Don't do the gas down the spark plug thing. It's a bad idea. Do the following >
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).

Drain the carburetor. There should be a screw on the lower side or bottom of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the
carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

Please rate this solution. Thanks!

2005 Gilera... | Answered on May 31, 2018

Not finding what you are looking for?
Gilera Logo

655 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Gilera Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5880 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

socbr

Level 1 Expert

48 Answers

Are you a Gilera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...