I have two problems, on a 2002 hyundai accent, one, i have to replace the wiper transmission, and dont quite see how it comes out, do you need to pull the fender off or something? two, the front driver window came off it track and i need to take the door apart, it took all the screws out and am getting hung up on the door handle, any advise? thanks , Ryan

SOURCE: Need fuses diagram for Hyundai Accent GL 1999

This is my msn [email protected] send me a message and i send you a foto of the fuse box with description of the wipers fuses

SOURCE: i cannot open my door seems handle is broken

make a wire hook and feel under window winder and pull ,cuirclip should pop out

SOURCE: hyundai accent '02 inside door handle & Lock removal

Removing the door is very tricky, trust me on this. I ended up breaking it the first time, so please learn from my mistake.

1. Remove all visible screws: 2 at bottom of door, 3 on front near hinge, 1 on inside the door lever. You will need an average size phillips screwdriver to do this.

2. On the door handle itself, you will see two circles. Pop the front one out. You will need a LARGE size phillips screwdriver to do this.

3. Once screws are removed, take a (standard) flat-head screwdriver, preferable one with a large face, and pry the triangular piece of plastic (that covers the outside SIDE mirror) off. This will aide in puting the door panel back on...TRUST ME!!!

4. Take the same flat-head screwdriver, and pry behind the door lock (at the same time, push forward toward the door hinge). The assembly should pop out.

5. Gently pry the door panel from the door, making sure not to break any unnecessary pieces along the way. The door panel should be hanging by the window sill opening.

6. This is where it will get tricky. It is advised that you use help with this part: Angle the door panel at a 45 degree angle. AT THE SAME TIME, slightly bend and twist the door lock handle until it fits through the hole. You will see the 3 pegs the held it in the door from before. Also note: Be careful not to break the 2 poles that are attached to the lock.

7. After popping the lock through the hole, you should be able to lift the door upward, and off the sill. Repeat these steps in reverse order to re-attach door panel.

Be careful not to rip sound-deadening paper found on inside of door unless you intend to remove or replace it! Not only does it prevent dirt and moisture from entering your door (and possible rusting it from the inside out), but it makes your speakers sound better too!

-SportTunerFreak

**It is also recommended to put a tiny bead of silicone on the inside of the door panel to help suppress any rattling, and prevent moisture and dust from entering. It also helps your screws obtain a tighter fit. Hope this helps!

SOURCE: replacing exterior door handle 2003 hyundai accent?

remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!

SOURCE: Hyundai accent 1997, the driver side door handle broke

taking off the door panel is a lot of work. i can explain it all to you if you still have the same problem. i've replaced all of my door handles for all 4 of my hyundai's doors, so i'm experienced in this department. would you like a step by step walkthrough still?