Hi there:
Are you check battery charge? Your Jeep crank but no start, right? Ot, jiust turn the key start feww seconds and then died!
Could be some problem with starter and battery charge or theft system. Check that Theft Security System closely, it may not be allowing power from
the ignition switch to the starter/solenoid. If power is there when
cranking, you may want to replace the battery cables completely instead
of the ends that you already did.
The first thing we need to do is Check for Fault Codes. Cycle the key from off to on three times ending with it on and watch the check engine light. After the last time you turn the key on it will come on and go out. After a pause it will come back and start flashing. It will flash up to 9 times and then pause. Count the flashes between the pauses - this is a code digit. Write down all the digits in order and post them here.
Dont work yet? Wiil need to check this specific section from the Grand Cherokee Repair Manual, there is the wiring for your security system. You can try to pull the
fuse to disable the alarm system, but it may not work. Some are wired
when they do not have power or then are not powered up it will disable
the starting of the vehicle.
Hope this helps. Keep us updated.
×