I have a 2001 chevrolet silverado with the following codes C0265,CO241 C0245 C0246 CO251. ABS & BRAKE LIGHT COME ON AND OFF Thanks Joey

Looks like you need an ebcm. You can check the ground under the drivers side door attached to the frame, make sure it is clean and tight.



DTC C0241-C0254 or C041-C054
Circuit DescriptionThe ABS relay supplies battery voltage to 6 valve solenoids. The electronic brake control module (EBCM) microprocessor applies the grounds needed to activate each solenoid. The low side of each solenoid coil has a feedback circuit to the EBCM microprocessor. When a solenoid is commanded OFF, the feedback voltage is high. When a solenoid is commanded ON, the feedback voltage is low.
Conditions for Running the DTC • The ignition is ON. • The vehicle speed is greater than 6 km/h (4 mph). Conditions for Setting the DTCThe EBCM detects an internal malfunction.
Action Taken When the DTC Sets C0241, C0242, C0245, C0246, C0251, C0252, C0253, C0254If equipped, the following actions occur:
• The EBCM disables the DRP/ABS. • The ABS indicator turns ON. • The red brake warning indicator turns ON. C0243, C0244, C0247, C0248If equipped, the following actions occur:
• The EBCM disables the ABS. • The ABS indicator turns ON. Conditions for Clearing the DTCThe conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.
Diagnostic AidsAn intermittent open/shorted solenoid DTC can be set by several different internal EBCM problems. Replace the EBCM if an open/shorted solenoid DTC continues to set intermittently.
Step
Action
Yes
No
1
Did you perform the ABS Diagnostic System Check?
Go to Step 2
Go to Diagnostic System Check - ABS
2

1. Use a scan tool in order to clear the DTCs.
2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

1. Use the scan tool in order to clear the DTCs.
2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.