I cant figure out how to replace the tag light bulb
You probably figured this out by now, but in case you haven't... Reach up behind the rear bumper, rotate the bulb holder counterclockwise, then withdraw the holder from the housing and pull the bulb out. In some instances, the license light housing is held to the bumper with clips, and if you have a step on the bumper the housing is removed by pulling the housing upwards while pulling out at the bottom.
SOURCE: tag light replacement
Push the entire assembly back into the cargo area of the vehicle - it is clipped to the frame. (You may need to use the blade of a screwdriver to pry it loose).
Remove the electrical feed cover (red plastic) from the assembly by depressing the side clip.
Now, holding the asssembly in your hands, remove the lense cover top from the black bottom by depressing the side inserts.
Pull out the bulb, and replace.
Reassemble in the reverse manner.
The entire job should take no more than 3 to 4 minutes.
300 views
Usually answered in minutes!
×