SOURCE: need head bolt torque settings for 200 landrover discovery 4.0 liter 241 cu.in.
Stage 1 20nm
Stage 2 +90 degrees
Stage 3 +90 degrees
SOURCE: shredding timing belt landrover discovery
U have a defective tensioner pulley or idler pulley due to a failed bearing
SOURCE: super dud! landrover discovery. overheating no
The impeller blades worn off water pump and not circulating enough water is a good place to start. have to remove and check if thats not problem flush entire system and see if any blockages or corrosion comes out
SOURCE: routing diagram for 2002 landrover discovery ser
There should be a diagram on a decal on the bottom side of your engine hood, or in the engine compartment somewhere. If not, wrap it around the crankshaft, and then work your way around, going flats to flats, and ribs to ribs. There may be a couple of combinations, but you'll get it.
33 views
Usually answered in minutes!
×