SOURCE: starter disabled due to theft system
the wire that goes to the ignition to the anti theft device is probably broken if you call a good locksmith they can go in through the steering column and fix it same thing happened to my 95 eldorado apparently cadillac designed the anti theft system to coincide with the ignition and is connected to the ignition with two wires that turn as the key is turned the wires twist and eventually they wear out
SOURCE: starter disabled due to theft system
Question? when it does disable it usually will say " starting disabled due to theft system remove key from ignition and wait 3 minutes'. Are you able to start car after the 3 minutes? or it wont period? My car does this alot to but I think its cause you have to unlock the car, get in it, shut the doors and then start the car because mine does it when i open the doors.
SOURCE: 1994 cadillace anti theft system
I just had this same problem with a '96 . do you have a vats key in your '94? you need to bypass the VATS system. read some of the blogs on this site and it will tell you how to do it. I fixed mine with a $2 resistor from radio shack.
SOURCE: 1997 cadillac deville anti theft
This might work for most:
Theft Module Re-learn Procedure without a T5O or T6O
During this procedure, the vehicle battery must maintain a minimum of 10.5 volts. If the battery is not fully charged or is weak, a battery charger may be connected.
NOTE The battery charger must NOT be set in 12 volt boost. This will prevent this procedure from working.
1.
Cycle the ignition switch to the "Run" position.
2.
Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
3.
Cycle the ignition switch to the "Run" position.
4.
Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
5.
Cycle the ignition switch to the "Run" position.
6.
Wait a minimum of 10 minutes, cycle the ignition switch to the "Off" position.
7.
Verify the repair.
and if not try this:
STARTING DISABLED/DUE TO THEFT SYSTEM/REMOVE IGNITION KEY"
If the Powertrain Control Module (PCM) does not receive the Fuel Enable message it will use the class 2 serial data line (CKT 1807) to tell the Instrument Panel Cluster (IPC) to display the "STARTING DISABLED/DUE TO THEFT SYSTEM/REMOVE IGNITION KEY" message on the Driver Information Center (DIC) . This will inform the driver of why the engine is not starting. When the ignition is turned "OFF", the IPC will start a timer and display messages to inform the driver to wait for the PASS-Key II timer to run out. The messages will read "WAIT 3 MINUTES", "WAIT 2 MINUTES" (after 1 minutes has passed), "WAIT 1 MINUTE", and "START CAR".
If the timer was not run out, the IPC will not send the Fuel Enable message. When the PCM does not receive the Fuel Enable message, it will command the IPC to re-start the message process.
This message is most likely caused by an improper key resistor value or the IPC did not properly sense the ignition key resistance.
good luck!
SOURCE: '97 Cadllac Deville Concours reading "Anti Theft System Problem"
make sure your key is clean try again, if not the system will tell you to wait 3 mins while key is in ignition this will reset the system and dash will tell you to start vehicle, you should be fine after that, common cause dirty key!!!!!!!!
168 views
Usually answered in minutes!
×