SOURCE: Fuel pump and electrical
its very likley that your fuse is blown. If you look it should be something like injectors a+b
SOURCE: 1997 chevy blazer key stuck in ignition AGAIN GRRRRRRR
I have worked on several vehicles with this same problem and each one was a relatively simple repair with no parts involved, first off the shift interlock has nothing to do with it and will not prevent your vehicle from going into park, it is designed to work ONLY when coming out of park. The problem your having depends on the type of shifter handle your vehicle has, if the release lever is on the bottom and you have to push up with your fingers to release it, then the problem is...there is a rubber type cover that surrounds the release button, after time it becomes distorted and bunches up preventing the shifter from fully engaging in the park position (even though it appears the vehicle is going into park)if your careful you can work the rubber cover out and your problem is fixed. If your shifter button is on the side and pressed with your thumb the cable needs to be adjusted, this cables only purpose is to prevent key removal except when in park and is easily adjusted, with the center council removed, if you look at the front of the shifter base you will see 2 cables that snap into the shifter frame, the larger one is the gear selector cable, the smaller one runs up to the steering column and operates the mechanism that prevents key removal, where the cable snaps into the shifter frame is where the adjustment is done and is identical to a kick-down cable used on older vehicles with automatic transmissions, right where it snaps into the frame there will be a button you can press down releasing a spring loaded adjustment arm, make sure you first mark the arm for reference then press down the button and adjust it a little either way until it functions properly, hope this helps and good luck
SOURCE: took out battery to clean - starter good and
TRY USING SCREWDRIVER AT SOLINOID IF STARTER TURNS REPLACE SOLONOID
If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_00678fd4800d19c5
SOURCE: how do you change a lock n key ignition switch on 1998 chevy 6 cy
STOP. STOP. STOP.
I WILL POST WITHIN THE HOUR.
In the meantime, click here for a few things you need to know before even considering working with undeployed airbags.
Mike
SOURCE: What is the ignition timing for a 95 Chevy pick up
The timing is to be set at zero TDC.The connector is on the passengers side under the hood against the fire wall.There might be a plastic cover over it.It is a tan wire with a black stripe.Sometimes it will be in the passengers side under the dash.by the blower motor.Same colors on the wire.The check engine light will come on when the connector is unplugged but it will go off after it is plugged back in and the key is cycled on then back on or start.Hope this helps.Good luck.
45 views
Usually answered in minutes!
×