SOURCE: Replacing water pump in 98 Lex GS300
Removal of the crankshaft front pulley/damper can be removed without any damage being caused to the cam belt.
They are a good fit on the shaft, I personaly use a lead tup, weighs 2lbs and will not damage anything if used properly.
Tap equaly all the way round the pulley, that should be ok.
SOURCE: 89 jeep cherokee powersteering leak
Put a clean piece of cardboard, thin plywood, or whatever, under front tires, large enough to cover area under vehicle from front bumper to just behind front wheels. Start it with power steering full & crank wheels back & forth a few times. Monitor for drops of fluid on surface, to isolate problem area. may need to sit all night. Or take it in to shop, have them put on hoist & diagnose.
SOURCE: how do i remove the Powersteering pump in my 1998
Replace the ps pump, brake fluid is not a lubricant, your pump is scored, raise the van, block it, remove the sheild, belt and right axle, and remove the pump, you will have to flush the system with 4-5 litres of PS fliud only. GOOD LUCK, RDJRP
Testimonial: "thanks for the feedback, I figured the pump is gone , so it is not worth the efforts to seal eery detail"
SOURCE: My 93 ls400 has a
the power steering pump and hoses are near to right engine side and exhaust pipe , go to workshop to repair , maybe a hose is broken
139 views
Usually answered in minutes!
×