THE WORD "deck" appears instead

WHAT DO U MEAN JUST FUSE?SEND PHOTO OF DASH PREFERABLY WITH ENGINE RUNNING!!

There are two procedures and it depends on whether your radio has the option of Auitomatic Tone Control. Here are both ways, with and without Auto tone Control.

Setting the Clock for Systems without

Automatic Tone Control

Press SET. Within five seconds, press and hold the

SEEK right arrow until the correct minute appears on

the display. Press and hold the SEEK left arrow until the
correct hour appears on the display.

Setting the Clock for Systems with

Automatic Tone Control

Press and hold HR until the correct hour appears on the

display. Press and hold MN until the correct minute

appears on the display. To display the clock with the

ignition off, press RECALL or HR/MN and the time

will be displayed for a few seconds. There is an initial

two-second delay before the clock goes into the
time-set mode.

I have this same vehicle and model. "Deck" refers to the trunk being ajar. The sensors seem to be fairly finicky and sensitive. I have no answer, however, as to why "deck" appears even when the trunk seems to be closed.

Hello, this message is actually reading Err SS: for one of your speed sensors. It will either come on when you hit a slippery surface or climbing a gravely hill. The speed sensors are mounted on your steering knuckle and react with a multi toothed tone ring mounted inside the sealed bearing. I have replaced a few of those bearings due to minor amounts of rust build up which can sometimes cause interference with the speed sensor signal. I hope this info helps...(subytech1)...

I'm not too sure but my family asked me if my car needed a service when the wrench appeared where the mileage usually is. The milage since the last one would say so.

You could have a bad oil sensor or there may be a leak somewhere causing the pressure sensor to trip... if you give it some gas when the light is on. Does it go off??

Depending on the milage, I think you may have both going back, take to auto zone for free diagnosis.

The computer is not talking to your dash or the dash is shorted out and needs to be replaced.

"P done" means there are no codes stored. If there were codes you would see P and 4 numbers.

Not sure where you live but if the gas you get has a higher amount of ethanol in it you will get worse gas milage.But there are many reasons that effect gas millage.