I HAVE AN FORD BANTAM 1.3i ROCAM BAKKIE AND THE PARK LIGHT AND DASH LIGHTS DOES NOT NOTHING WRONG WITH THE FUSES WHAT COULD BE THE PROBLEM

no year car told. (will Assume starter cranks fast)
NO SPARK (fire only happens with fuel) fueling is last.
when did it last run this car, last week, month, year, ? or never
as in fixing dead car for friend ,etc? for found a dead car?


spark that is called,the High voltage HV ) spark coil makes spark happen on all gas engines. and evolved radically from 1990 to now.
so your not telling cars year, country, makes answer frankly impossible
Generic answer next. (4cyl. 1.3L)

• fuses blown. (we check them all, )
• icm bad, or bad distributor. or installed wrong.
• 2 coil packs,? 1,3,4,2 fired, and wired backwards (OOPS)
• COPS bad. (coil over plugs x4)
• CKP bad
• CMP bad
• cam belt slipped making CMP and CKP LIE and ECU ignores them. or fires sparks in WRONG TIME.(varies by year made)
• wires bad to all that. or connector, there.
• key switch bad (ing pin)
• bad spark coil HV,or HV wires sets bad. to distrib or to coil packs.
• always test all spark plugs not just one., or bark up the wrong tree easy.

if 2 coil packs the HV lugs most not connected wrong,
or spark firing order is lost.
if 2coil packs, 1 spark plug or 1 HV wire fails 1 spark plugs die
and 4cyl with only 2 sparks good cannot RUN.
1,3,4,2 is order.

1983 to 2011 years wiki says

The Ford Bantam is a coup? utility/pickup (known in South African English as a 'Bakkie') produced in South Africa. Production of the Bantam spanned three generations, with the vehicle produced in South Africa for sale within the South African market.

Brazilian-designed Rocam engine is of single overhead-cam configuration with two valves per cylinder.
2002 to 2006, it says.
Zetec Rocam (Duratec 8v) was cam chain driven, but I'm not sure, none sold here.USA

no info generic answer does it get fuel ---battery weak etc

Disconnect the battery - negative cable for 5min connect it back and try start it should work

First check fuses and globes/undo screws holding the covers on the column unplug the wiring undo the screws to the combo switch.

Have you looked in the fuel tank?

Specifically for a Ford Bantam 1.3L/1.6L Rocam...

hi.you can check the balbs if thats ok it can be the switch or a earth conection

standard fuse is 15 or 20 amp will not hurt anything if you use either ,

bantam?
most cars, MPI injection the injector form a sandwich.
between the fuel rail, and the intake front tunnel tubes.
so remove the rail,
step s
remove battery neg lug, so some, odd person dont try to start car.
depressurize the fuel system per FSM.
then remove injector conn plugs.
the unbolt rail. bingo.

the FSM covers this, ask ford parts counter for this book.

The Ford Bantam is a coupe utility vehicle ("bakkie", "pickup", or "ute") produced by the Ford Motor Company in South Africa. It spanned into three different models and was produced in South Africa for the local market.

be safe.

Hi,i had the same problem and last night i changed the complete light switch unit and all iss working now,so the light switch unit is faulty.