HOW DO I RESET THE 'MAINTENANCE NEEDED' LIGHT?

you need to hook it up to a scanner to reset it

This procedure is suppose to be done buy a service tech that has changed you engine's oil. If they have forgotten and you want to reset the light, then it is acceptable. The procedure is easy. Step one:(with the key out of the ignition) gently press and hold in the mileage reset button. Step two: (Still holding the button in) slide the ignition key into the ignition and turn the key to the run position (do not start the engine) Step: wait 10seconds and you will see the "Maintenance Light" go out. Now let the button go. Step five: turn the ignition key back to off and the Maintenance Needed light is now reset. I hope that helps, let me know, good luck.

It's a manual reset slot. You have to insert your ignition key all the way into the slot next to the maintenance light and it will push in and reset the light.

It's just a mileage-triggered light that reminds you to perform routine maintenance on your vehicle. It can be reset. Instructions to reset should be found in your owners manual or on Youtube.

It means the car thinks it needs an oil change. Has the oil been changed recently? If not it is probably due. If the oil has been changed recently let me know and i'll let you know haw to reset it.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.

Service interval indicator can only be reset using a suitable diagnostic tool.

Sorry!

Maintenance is needed depending on the mileage, anything from an oil change to a major service. then the light can be reset.

Hi there. Here is what you do:

-Press and hold down the odometer reset button
-Turn the key to Start (But don't start the car)
-Keep holding the odometer button until the Maintenance Req'd Light stops blinking.
-Turn the key back and remove
-Let go of the Reset button
-Turn the key all the way and it should be gone.

good luck and please rate my answer. thanks