Need to know the hole stop switch brake asembly

Brake light checkout:

The brake light switch is on the brake pedal arm.
You can adjust it or replace it. Usually the problem is a rubber stop falls out and the switch end goes into the hole and never actuates.
Look around there and check that area out.
Hope this helps.

Without a diagram I have no idea

If you look close up where the brake pedal goes,you are going to see a hole on a plate where the pedal stops,there is where the switch goes.

Remove the cover from under the dash and look up above the brake peadle about 5 inches you should be able to see the switch there may be 2 switches if you have cruse contronl. The brake light switch should have white and orange wires. just pull back on the switch to remove it. When putting the new one in push the brake peadle in then push the switch all the way in the hole then pull the brake peadle back till it stops this will push the switch back out some this will adjust the switch. Of course ckeck for proper operation. Here is a bad diagram of the switches but it the only one I could find.

The brake light switch is at fault. Get a new one and replace it. The location is at the brake pedal area mounted on a bracket with a plunger stud that rest on the brake pedal's arm the pad is attached to

yes.. under the brake pedal or somewhere right underneath the wires is a switch .. its rectangular and you should be able to pull it out and replace it easily..

Look in the owners manual...it should have access instructions for this bulb. Or, try calling (or stop by) a dealer. the "service consultant" or service manager should be able to quickly tell you how to access the bulb.

When you depress the brake pedal, the brake pedal will move away from the brake light switch and cause a close circuit and the brake lamps light up. There is a rubber bunk on the pedal which pushes against the brake light switch to shut it off when you release the brake pedal. Most likely this rubber bunk has either fallen off or disintegrated leaving a hole in the brake pedal so there is nothing to push against the switch to shut it off. Look up the brake pedal until you see the brake light switch, then depress the brake pedal to see if the rubber bunk is still there. It is easy to replace. Or you can use some double sided adhesive tape and a coin and stick the coin over the hole in the brake pedal.

YES YOU HOOKED IT UP WRONG.
SWITCH THE CABLES.