Question about Buick Rainier
Sorry to say there is no cabin air filter in a 2006 Rainier. Call your closest Buick dealer and they will tell you the same thing.
Posted on Apr 11, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: cabin filter element location
Filter is located behind the glove box. All you need is a screwdriver to replace.
1. Open the glove box and empty to take the weight off the box.
2. On the right side there is a plastic hinge like device held on by one Phillips head screw. If you have trouble removing with a Phillips screwdriver you can remove with a narrow flat head screwdriver. Remove the screw and slide hinge off the mount.
3. To drop the glove box press the sides slightly inwards while 'forcing' it open beyond it's normal stopping point. Careful as when it releases it will fall wide open and may even fall from its hinged area. Set it aside.
4. Behind the glove box there is probably some fiberous material inserted to prevent noise like squeaking when it rubs. It is sticky on one side to hold it in place. Just remove and place out of the way.
5. Behind the fiberous material there'll be a cover which kinda looks like a grille. Mine was white and it is in the center of the opening. Remove it by releasing the clips at the left or right. It comes right out.
6. When the cover comes off slide the filter out and replace it. The filter lays flat and just slides in and out easily. However, if it has been some time since you replaced be prepared for a lot of debris on top of the filter such as leaves, grass or other general type of debris that has been sucked into the filter. It also may be the source of any bad odors that you smell through the air conditioning system.
7. Reverse the process. Replace the cover and push the glove box lid back into place. When you replace the glove box be careful to make sure the hinge you initiallly removed the screw from is not left behind the glove box or you will have to remove again to get it out. Replace the screw and do not over tighten as it screws into plastic and then your done.
Posted on May 07, 2009
1. Open glove box
2. Unhook elastic retainer on right side
3. Locate the two "stop tabs", one on the upper left and the other on the right side. Push both to the left to clear their stops and the glove box will swing down, allowing access to the filter cover.
Posted on May 06, 2009
We had to remove the glove box first then on the centre consol there is a small removal plate, remove this and locate the filters. There are two .
Posted on Apr 23, 2009
To change the cabin air filters (there are two, that are in same location), you first have to remove the glovebox. The glovebox itself will not come off. You have to get a phillips head screwdriver to remove the 5 screws. With the glovebox closed, locate the two screws underneath and remove, one on each side. Next open the glovebox, remove the two screws at the top. The fifth screw is on the right behind the plastic molding. Pull back on the top of the lower piece of molding until the bracket pops out. The piece of plastic located just above that piece needs to be pulled out. No need to take it out all the way, just enough to get to the screw. Once removed, with the glovebox open take the fuse panel cover to the right off to allow you better grip. Pull both sides evenly until glove box pops out.
Get a flashlight and shine it on the right side behind where the glovebox was. There is a small plastic cover about 1 inch tall by 5 inches long. It is clipped in place. Push up on the plastic clip with your thumb while pulling out and down with your other finger/fingers. Behind this is one filter. Remove it best you can. Be careful, mine had dead bee's/wasps/dust/dirt/pinestraw/etc. After removing the first, you will notice a second one to the right of that. Slide that one to the left and remove the same way as the first. Look at those filters when you remove and take note the direction of AIR FLOW ^marking. Before replacing with the new ones, vacuum out inside where the filters go as best you can to remove all that crud that fell off of the old filters when removed.
Reinstallation is the reverse of how you removed. I hope this helps all my fellow Pathfinders out there.
Posted on Jun 07, 2009
The cabin air filter is behind the glove box. The first thing you need to do is empty the glove box. (2) you need to remove the side panel that runs along the side of the shifter, it is a long panel and has on clip near the firewall, the clip will have a phillips head on it, just back it out and remove this panel. Then remove all the bolts (10MM) holding the glove box on, The glove box is will stay up because it has two hings that run into the sides of dash. All you need to do is squeeze the glove box untill it pops out and the glove box will be out. There is no need to unhook the wiring for the light bulb just let the glove box hang on the floor. Now you will see a black cover that is held on by 4 small metal clips, remove these and pull the cabin air filter out. when you reinstall the new one, make sure you put it in with the air flow arrows pointed in the right direction or else you will cause blockage. reinstall and enjoy your new heppa filter
Posted on Jun 25, 2009
Tips for a great answer:
Feb 05, 2016 | 2006 Chevrolet Chevrolet Malibu
Dec 05, 2015 | 2006 Buick Rainier
Aug 04, 2015 | 2006 Buick Rainier
Sep 29, 2014 | 2006 Buick Rainier
Jun 05, 2013 | 2005 Buick Rainier
Mar 10, 2011 | 2006 Buick Rainier
Jul 30, 2010 | 2007 Buick Rainier
May 22, 2009 | 2004 Buick Rainier
Nov 26, 2008 | 2006 Honda Accord
1,941 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: