Turn signals stopped working one day. we let it sit all winter. they go off when the alarm goes off. what is it. and whats the relay fuse number for turn signals?

There should be 6 relays in the fuse box. Using your manual, find the turn signal relay and replace it.

TURN KEY ON , REMOVE FUSES ONE AT A TIME ,TILL PROBLEM STOPS ,CHECK COMPODENTS , DIS CONNECT WIRES ONE AT TIME TIL PROBLEM STOPS,REPLACE DEFECTIVE PART OR RELAY

My problem started after a low battery also. It is a different problem than yours but it might solve your problem. Here is my solution. I believe it's worth a try for the price. All signs point to the Accessory Relay (NOT the Accessory Delay Relay). I replaced the Accessory Relay (Standard Part V13081 RY612). It cost me $15.61 with tax. On the 2004 Ford Escape, it is just to the right of the fuses in the fuse box by the driver's side seat. Three days and all good so far. It is well worth the price to see if this works for you like it worked for me.

Which fuse ? Number an amp rating .

If it is the horn, pull the horn fuse or relay. Does the vehicle start and drive, ok? Of course, pulling the fuse or relay isn't the proper fix. I'm just talking about killing the horn, where applicable.

If it is the horn that keeps going off, pull the horn fuse, that should stop it till you figure the problem. The bcm can ground the control side of horn relay as well as the horn switch. I'm not saying the bcm is faulty, I don't know, at the moment.

check your wiring harnmess and make sure bare wire is not touch other wire this will call to flown fuse.

sounds like the flasher can might have stopped working, you will need to get it replaced, it regulates the indicaters to blink, when it goes the circuit is gone, time for replacing id say. check the relays in the main fuse box under the bonnet first, try swapping the relay with another one like the horn relay just to test that first.

Check the flasher and brake light relays. Check relays under hood in electrical box to make sure they are seated properly and not loose.

hello,good day,your alarm signal is actuated by your left front control module or left front sam,you mention you replaced your wiring harness,maybe some mix-up,tryn to check again your wiring connection,your alarm have 3 connection, terminal 1 is always live, 2 is ground,,3 is connected to your left module number 4 socket with number 3 pin (blue red wire) try to check,and post your evaluation,ty