On a 96 chevy cavalier, where is the abs wheel sensor located?

With enough time and money you can make a front wheel drive car into a rear wheel drive car. You would have to replace the transmission and axles and it could cost well over $10,000.---------------------------------------------------------------------------------------
fgtech galletto 2-master

just behind the front disk and inside the hub or brake drum on the rear

Toyota cavalier??? Chevy tacoma???
You might have a wheel sensor issue (part of the wheel bearing assembly) It tell the abs computer the wheel speed, and if one is bad, it will error the abs, and turn the light on. You can get this checked with an abs scanner hooked up, or ohm out all of your speed sensors with a meter.

Service light can be turned if with an OBII scanner (Autozone or any good parts store can reset service light for FREE) The ABS & trace control lights are in because you have a wheel sensor(s) that are bad - replace bad sensor and then a certified shop or dealer has to reset ABS light (EXPENSIVE TOOL)

YOU HAVE AN ABS PROBLEM- TAKE TO REPAIR SHOP.

you will have to check the abs wiring harness. the wires going to the wheel speed sensors are more than likely broken setting the code and turning the abs light on. hope this helps.

The abs fuse is located in the fuse block under the drivers side steering wheel,its the fuse number 25.

there are located at the center of hub in the rear, and the front is also near center onthe side of were the axle goes into the hub, good luck.

First check your brake fluid.
Either you have a failing brake booster, or you have developed a leak in one of your brake lines. If your brake line is leaking, it should be pretty evident, i.e. oily looking substance sprayed underneath the vehicle or in the wheel wells, if the booster is leaking (the large black/silver almost bowl shaped thing directly in front of the driver under the hood against the back wall) there will most likely be fluid dripping down the firewall below it, if your brake fluid is extremely low/empty, you probably have a leak, that could be at the booster or on a line, or even at the caliper/drum. If it is empty (which can make your ABS light, light up) then you have yourself a leak. Also, if the fluid is really low, you could try adding some, although you will have air in the lines if it was low enough to floor the brake, but you might be able to find the leak if you refill the fluid and cause it to spray from the leak again. Have someone watch under the vehicle while you do this.

If your ABS light is on as well, have a shop scan it (it requires a special scanner). If it's just your Trac light without ABS, it is most likely a sensor under the hood at fault. If you are getting a check engine light as well, get the codes read!
This happened to me without an ABS light and it was the upstream O2 sensor. The reason it throws the Trac light is because if any components that the traction control uses (ignition, fuel) are affected by a bad sensor, the PCM shuts down traction.
In fact, when I replaced the O2 sensor, a handful of other little issues resolved as well.
If you do have an ABS light on, it could very well be a wheel speed sensor.